Advertisement
ASSEMBLY INSTRUCTIONS
1.
REMOVE PRE-ASSEMBLED TRIPOD
2. ADJUST TRIPOD TO PROPER HEIGHT BY LOOSENING,
ADJUSTING AND TIGHTENING THE LOCKING KNOBS.
3. REMOVE TELESCOPE AND MOUNT FROM CARTON.
NOTE: THEY COME PRE-ASSEMBLED FROM THE FACTORY.
4. LOOSEN MOUNTING KNOB ON THE TELESCOPE
MOUNT (UNDERNEATH)
5. PLACE THE TELESCOPE AND MOUNT ASSEMBLY
ONTO THE TOP OF THE TRIPOD.
6. TIGHTEN LOCKING KNOB (UNDERNEATH THE TRIPOD TOP) SECURELY.
7 ATTACH ACCESSORY TRAY AS SHOWN.
8. ATTACH ELECTRONIC MARS-EYE FINDER.
9. USE THE TWO THUMB SCREWS TO POSITION THE
ELECTRONIC MARS-EYE FINDER ON THE TELESCOPE
TUBE. FOR ADDITIONAL HELP SEE THE PAGE IN YOUR
INSTRUCTION BOOK FOR ELECTRONIC MARS-EYE FINDER
MOUNTING AND ALIGNMENT.
IF YOU NEED ANY FURTHER HELP WITH YOUR GALILEO TELESCOPE
PLEASE CALL US @ 305-245-8444 MON-FRI 9AM - 5PM E.S.T
OR E-MAIL US AT CUSTOMERSERVICE@COSMOSOPTICS.COM
GALILEO G-860WG
CAUTION: NEVER POINT YOUR TELESCOPE
AT THE SUN. VIEWING THE SUN
THIS TELESCOPE OR EVEN THE UNAIDED
EYE CAN RESULT IN BLINDNESS OR OTHER
SERIOUS EYE DAMAGE.
5
WITH
WASHER
KNOB
Advertisement
