Summary of Contents for TECHNO-MEDIA SAT-TV 40
- Page 1 UMN_00094001 User Manual With Controller Beep Box 2 TECHNO-MEDIA srl Via IV Novembre 92, 20021 Bollate (MB) tel. 0248672988 - info@techno-media.it...
-
Page 2: Document Revision
Minor Changes 23/04/2015 T-Media Minor Changes 01/03/2016 T-Media Added BeepBox Ver 1 02/03/2016 T-Media Added Dish Focus Tuning 08/03/2017 T-Media Added Conenction BeepBox FastOn UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 3: Table Of Contents
BeepBox with preassembled Wires........................ 19 BeepBox with FastOn connectors ........................20 How to connect the Set Tob Box ........................21 USE of the System SAT-TV 40; 65; 80 with BEEP-BOX 2 ................23 Description of the system ..........................23 Switching ON ..............................25 Switching OFF .............................. -
Page 4: Introduction
Symbols in this manual Read the Manual. Respect indication to avoid risks for user. Only qualified person of TECHNO-MEDIA srl. Pay attention. Correct. Wrong. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 5: Technical Specification
Protection Fuse line and the secondo ne on the ignition line. Both inside the Beep Box. Height Width Depth Dimension with dish closed 21cm UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 6: System Components
‘User Manual’’ Automatic Satellite Antennas TECHNO-MEDIA SRL System Components Inside the box you will find: Automatic Antenna SAT-TV 40 or 65 or 80 based on what you purchased. 5 Meters Ethernet cable to connect the Antenna and The Beep Box. - Page 7 2) Beep-Box 2 This one allow to switch off the antenna in order to easily download the new settings for your Set Top Box. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it...
-
Page 8: Warranty
If there is no service center in your area, please send the antenna in its original packaging at TECHNO-MEDIA srl. with a detailed explanation of the defect. For added traceability, it is required to send an email to: info@techno- media.it... - Page 9 • Use of non-original parts. • Failures caused by adverse weather conditions such as lightning, hail and strong wind. • Failures caused by supply voltage or incorrect connections. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it...
-
Page 10: Installation
3. There is no risk to fall down from the roof or from the aids used to reach it. 4. Do not stand in a risky position where tools or material can fall down during the installation. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 11: Dish Assembly
Align the 2 plates with the dish and the main body Set the four screw firmly UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 12: Arm Focus Tuning
To the junction between the arm and the plastic of the LNB handler. Now switch ON again the Antenna and wait for the complete process. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 13: Antenna Installation
The arrow in the figure indicates the direction of march of the vehicle. Be sure that the antenna is parallel to the sides of the vehicle. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 14: Passage Of The Cables
DO NOT pull on the cables, you might run into the cable break and then the antenna malfunction. Such failure is not covered by warranty. Ethernet cable 5 meters NOT cross UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... - Page 15 Connect the RJ45 connector of the Ethernet cable to the antenna connector, as shown in the figure, insert the connector until the retaining tab does not Click UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it...
-
Page 16: At This Point The Antenna Installation Will Proceed In The Vehicle. Had It Not Been Executed Yet, Be Sure To Fully Sealed Waterproof Box Or Previously Mounted Cable Guide
At this point the antenna installation will proceed in the vehicle. Had it not been executed yet, be sure to fully sealed waterproof box or previously mounted cable guide. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 17: Installation Of The Control Box Beep Box Version 1
12V line which is powered only when ignition key is turned or the vehicle is ON. Keep the BeepBox in an accessible position. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 18: Installation Of The Beepbox Version 2
Take the SCART-SCART cable ** from the package and connect the RCA connector to its connector on the controller. Refer to the figure on the side UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 19: Beepbox With Preassembled Wires
YELLOW WIRE to a 12V line which is powered only when ignition key is turned or the vehicle is ON. Refer to the below picture UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 20: Beepbox With Faston Connectors
12V line which is powered only when ignition key is turned or the vehicle is ON to the Right FastOn. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 21: How To Connect The Set Tob Box
[2] of the cable and keep the RCA [1] connector connected to the Beep-Box. If your decoder and your TV support it connected the HDMI cable. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... - Page 22 Connect the power cord to the Set Top Box [2] and if the system has one, turn on the switch [1] UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it...
-
Page 23: Use Of The System Sat-Tv 40; 65; 80 With Beep-Box 2
‘User Manual’’ Automatic Satellite Antennas TECHNO-MEDIA SRL USE of the System SAT-TV 40; 65; 80 with BEEP-BOX 2 Description of the system Every system, use an automatic process to point the satellite which does not require intervention by the user. - Page 24 Set Top Boxes like SKY and/or PAY PER USE. In this case you have to switch off the receiver using the power switch or disconnecting the power cable. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it...
-
Page 25: Switching On
CLOSE button. After the antenna close down, an infinite series of beep is played until the receiver power is not removed or the OFF button is pressed. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... - Page 26 (yellow cable MUST be connected). A continuous beep will be sound until the antenna is in movement, does not move the vehicle until the beep is present. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it...
-
Page 27: Satellite Searching Process
If at the end of the loop no satellites are found, the scan is performed again with different settings. If at the end of all scanning processes the satellite is not found, the antenna will close down. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 28: Programming The Receiver Type
Press and keep pressed the CLOSE button. Then a long quick sequence of beeps is played. This is confirming that the new setting has been saved. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 29: Protection
Take all necessary precautions if you must get on the vehicle roof. Avoid using metal rods for the removal of obstacles when weather conditions are adverse. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 30: How To Update The Receiver Channels
4. To start the update process refer to the Set Top Box user manual.. 5. Switch on the Antenna only at the end of the Set Top Box update process. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 31: Beep Signaling Details
Antenna in protection mode due to an obstacle which does not allow the 2 sequences of 3 Beep system to move properly. Remove the obstacle and press CLOSE to reset. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... -
Page 32: Problem And Solutions
Double check if the channel on the STB is properly programmed Sometime the STB get blocked and needs to be switched off and on. UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it... - Page 33 ‘User Manual’’ Automatic Satellite Antennas TECHNO-MEDIA SRL UMN_00094001 Vi ringraziamo per il vostro acquisto UMN_00094001 Rev 7 TECHNO-MEDIA SRL Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - info@techno-media.it...
Need help?
Do you have a question about the SAT-TV 40 and is the answer not in the manual?
Questions and answers
Off funktioniert not given