Advertisement
Quick Links
(rev4 June 2014)
Mounting instructions for ThermalCapture
Thank you for buying our product. The following instructions will guide you through the
process of mounting ThermalCapture to a TAU core. Please read these instructions
carefully before you begin.
Step 1: Remove the VPC Module
If your TAU Core has a VPC-module, please remove it by loosening the marked screws.
The VPC-module and the two screws are not needed in the following process and can be
put away.
Step 2: Remove the back cover
Remove the back cover by loosening the marked screws.
The back cover and the four screws are not needed in the following process and can be
put away.
Caution: This will also release the main-board of the Tau core. It will be kept in place only
by its internal wiring. Do not apply strong forces to the main-board at this and the following
step. The internal wiring pulls the main-board down at the upper side of the TAU core, so
that the main-board moves a little bit up at the other side when the screws are released.
Advertisement
Summary of Contents for TeAx Technology ThermalCapture
- Page 1 Mounting instructions for ThermalCapture Thank you for buying our product. The following instructions will guide you through the process of mounting ThermalCapture to a TAU core. Please read these instructions carefully before you begin. Step 1: Remove the VPC Module If your TAU Core has a VPC-module, please remove it by loosening the marked screws.
- Page 2 At the end of this step your TAU core should look like this:...
- Page 3 Step 3: Apply the new back cover For this step you need the TC Aluminum ground plate and 4x M1.6x6mm countersunk screws from the screw set. Stick the four screws through the marked holes and apply the back cover to the Tau Core carefully.
- Page 4 After this step your TAU core should look like this: Step 4: Mount the ThermalCapture board For this step you need the ThermalCapture board, 3x M1.6x6mm cylinder screws, two insulating discs and the small distance sleeve from the screw set.
- Page 5 Apply the distance sleeve to the screw at the green marked position. The distance sleeve must be added between the board and the ground plate. Connect the ThermalCapture board to the TAU core carefully. Do not apply strong forces. Be careful especially with the both screws near the connector. Tighten the screws not stronger than necessary to keep the board safely connected and in position.
- Page 6 Step 5: Apply the back cover For this step you need the TC CRFP cover and 4x M1.6x3mm screws from the screw set. Connect the internal trigger connector to the board as shown in the following photo:...
- Page 7 Mount the back cover and attach it with the four M1.6x3mm screws.
- Page 8 Congratulations! You have successfully mounted ThermalCapture to your Tau core. Please proceed with the chapters wiring and software configurations from the user guide.