Speco SP6PB Quick Start Manual

S P 6 P B / S P 6 P W
S P 6 P B / S P 6 P W
6" Pendant Mount Speaker with Optional Ground or Wall Mount
Thank you for your choice of Speco Technologies' SP6P combination speaker. This unit is designed and manufactured to
provide an extremely versatile solution for background music and paging. Out of the box, the SP6P is a pendant speaker. With
the optional mounting kits, the speaker can also be mounted on a wall or in the ground as a landscape speaker.

SPEAKER FEATURES:

1) Transformer Dial to determine speaker power (Only on SP6PTB and SP6PTW). Use a flat-edged screwdriver and turn until the left
end of the groove points towards the power value you desire. Options are 32W, 16W, 8W, 4W, and 8 Ohms. For all settings but 8
Ohms use a 70 or 25V amplifier (depending on what you set #3 to). For 8 Ohms, use an 8 Ohms amplifier.
2) Socket for pendant mount eye-bolt. Eye-bolt should be inserted through Speaker Top A described below.
3) Transformer selection switch (Only on SP6PTB and SP6PTW). Alternate between 70V and 25V. This switch should never be used
while speaker is live on an amplifier. Connecting the speaker to the wrong amplifier could damage your speaker or amplifier.
4) Speaker terminal (phoenix connector). Use this to connect to your amplifier and to another speaker. Please consult an expert if you
are not familiar with proper wiring practices.
5) Landscape/Wall-mount wire channel. Insert speaker wire under metal bar to fortify installation.

INSTALLATION INSTRUCTIONS:

1) All speaker adjustments must be made either before connection to amplifier or while amplifier is off to avoid potential damage to
equipment.
2) If you have the SP6PTB or SP6PTW, select first which voltage you are using via the switch described in #3 above. Then, select the
speaker wattage you want via the dial described in #1 above.
3) If you have the SP6PB or SP6PW, no adjustments are necessary.
4) There are two speaker tops that come in your package. The
difference is easily identifiable as one will have a built-in screw
(B), and one has two openings (A). (Pictured right)
5) Top A is the top you will use if you did not purchase the
optional mounting kit and wish to pendant mount the speaker.
To install with top A, you will need to run your speaker wire
through the top prior to connecting to the phoenix connector.
Connect the positive wire running from your amp or adjacent
speaker to one of the (+) terminals on the connector. Connect
the negative wire running from your amp or adjacent speaker
to one of the (-) terminals on the connector. If you are daisy-
chaining 70V/25V speakers, use the second (+) and (-) terminals
to connect to that speaker and repeat. (Pictured following
page)
/ S P 6 P T B / S P 6
/ S P 6 P T B / S P 6
P T W
P T W