TRACKIMO TRKM017-3G User Manual

top
button
Charging device
Trackimo Watch has a built-in battery to charge it, connect the magnetic end of the USB cable (5) to the charging
port (6) on the back of the device, and plug the end of the magnetic USB cable to a USB charger or to a computer
that supports the USB interface.
Charge the device for 12 hours before the first use. The device should be switched on after a few minutes from the
start of the charging process, if it does not, disconnect the device from the charger and press and hold the on/off
button (1) for approx. 3 seconds.
Buttons
•
Turning the device on/off
Press and hold top button (1) for about 5 seconds.
•
Setting time
Connect the device to a power source and then press and hold the bottom buton (3) to enter the time
setting mode. Press the top buton (1) and the bottom buton (3) to change the time. Press and hold the
bottom button (3) to save the time settings.
After the first calibration of the GPS module, the device will automatically set the time zone to 0. To make the
device display the correct time, change it by setting the time above.

User manual

Trackimo Watch
1
speaker
2
reset
button
bottom
button
3
4
magnetic
USB cable
charging
5
port
6