Advertisement
TO ADJUST TK MANUAL FLANGER:
PHOTO No. 2
PHOTO No. 4
1. (A) SET SCREW (4mm HEXAGON) TO ADJUST LOCATION OF (B) TOP FLANGER HEAD. See
photo 4
2.
(C) SET SCREW (4mm HEXAGON) TO ADJUST LOCATION OF (D) BOTTOM FLANGER HEAD.
photo 5
See
TO ADJUST TK MANUAL FLANGER:
1. LOCATE SET SCREW (C). LOOSEN TO ALLOW REPOSITIONING OF BOTTOM FLANGER HEAD (D),
SO MATERIAL WILL SMOOTHLY SLIDE DOWN FLANGER MATERIAL REST PLATE (F), WITHOUT
INTERFERENCE OF THE BOTTOM FLANGER HEAD (D). See photo No. 2
2. ONCE PROPER ALIGNMENT IS ACHIEVED, RETIGHTEN SET SCREW (C). See photo No. 5
3. LOCATE SET SCREW (A) LOOSEN TO ALLOW REPOSITIONING OF TOP FLANGER HEAD (B), TO
ALIGN / MATE WITH BOTTOM FLANGER HEAD (D). See photo No. 4
4. ONCE PROPER ALIGNMENT IS ACHIEVED. (See Photo No. 3) RETIGHTEN SET SCREW (A). See photo
No. 4
PHOTO No. 3
PHOTO No. 5
4
Advertisement
