Download Print this page

Penfore MU-600-T Installation Manual

Advertisement

Quick Links

MODEL MU-600-T
The MU-600-T is designed for use with the MU-600-R8 and MU-600-R16. Please refer to the MU-600-R8 or
MU-600-R16 manual for installation and operation related to the MU-600-R8 and MU-600-R16.
Reduce risk of fi re or electrical shock. NOTE: This installation should be made by
Do not expose this product to rain
or moisture.
Installation: MU-600-T Transmitter-end
1)
At the camera location securely mount the transmitter unit.
2)
Find the Link cable from the head-end and make sure it is properly terminated. Connect Link cable to the
"Link Port" of the transmitter. If the head-end unit is powered up it will sense the connection to the transmitter
and turn on the power. This will be indicated by the green POWER LED on the "Network Port".
After about 15 to 30 seconds the amber 10/100Mb LED on the "Link Port" will turn-on to tell you that the
system is connected. An Ethernet device does not need to be connected for the transmitter to communicate
with the head-end.
3)
Finally, connect an Ethernet device to the transmitter's "Network Port". If the device requires PoE power, the
GREEN POE OUT, LED on the "Link Port" will turn on followed by the LINK AMBER STATUS LED on the
"Network Port". The IP camera or other Ethernet device should now be ready to operate. Continue installing
the remaining transmitters as needed.
Transmitter Hookup Diagram
IP Camera
IP Camera
Network Port
Network Port
LED INDICATORS
Connector
LED
Power
Network
Port
Link Status
POE Out
Link
Port
10/100
IEC/UL 60950-1
(FOR USE WITH TWISTED PAIR CATEGORY CABLE)
Cable from
head-end
Cable from
Head-end
Link Port
Link Port
OFF
ON
Power
No Power
Good
No Ethernet
Ethernet
Link
Link Good
No POE
POE Power
Power Out
Good
No Link
100Mb
MADE IN
USA
INSTALLATION
MANUAL
a qualifi ed service person and
conform with local codes.
Distance
100m
FLASHING
200m
300m
400m
500m
600m
10Mb
* Results with ER8500 Receiver and
using 4 pair CAT5+ cable
PoE Device Power
4 pair CAT5+*
Power at PoE Port
27.4 watts
27.4 watts
25.0 watts
20.0 watts
18.0 watts
14.1 watts

Advertisement

loading

Summary of Contents for Penfore MU-600-T

  • Page 1 MODEL MU-600-T (FOR USE WITH TWISTED PAIR CATEGORY CABLE) The MU-600-T is designed for use with the MU-600-R8 and MU-600-R16. Please refer to the MU-600-R8 or MU-600-R16 manual for installation and operation related to the MU-600-R8 and MU-600-R16. Reduce risk of fi re or electrical shock. NOTE: This installation should be made by Do not expose this product to rain a qualifi...
  • Page 2 INSTALLATION MANUAL Optional Hookup for High Power PoE IP Network Devices with MU-600-T Units In some cases the PoE device connected to the transmitter needs more power than can be supported over a long cable run. You can usually identify these cases by watching the POWER LED of the transmitter, located on the “Network Port”. If the power light cycles ON for less than 1 second and then is off for 3 or 4 seconds...