Advertisement
REMOTE START FUNCTIONS
FUNCTION
VALET BUTTON
Press 2x after Engine Running For
This will leave the engine running for the programmed run time (XL mode runs for 12 hours) so you can take your
Pit Stop Mode
2
More Than 10 Seconds
keys with you to run errands.
(Press 6x for XL mode)
Low Battery & Low/
Ignition Key ON, OFF, Press 2x
Auto-start will activate a max of once per 2 hours. See your installer or the full manual for threshold settings.
Hi Temp Auto-Start
This disables remote start and the security system. The status LED will turn on. Repeat this process or press valet
Valet Mode
2
Unlock, Hold For 3 Sec.
button once to exit valet mode. TIP: You can also enter valet mode by holding the valet button for 3 seconds!
MANUAL TRANSMISSION RESERVATION MODE
2
This must be performed before you can remote start a manual transmission vehicle to ensure the car is in neutral &
maximum safety. Consult your installer for more information.
1) With the engine running (more than 10 seconds), hold the brake pedal & place the transmission in neutral.
2) Apply the parking brake and release the brake pedal.
3) Send the remote start command via your remote. The remote start should engage
(not crank) and the status LED will begin flashing.
4) Take the ignition key out of the switch (the engine should stay running).
5) Exit the vehicle and lock your doors with the remote. The engine will turn off.
2-These functions are only available on some remote start models. Consult your installer for more info.
2
1 Button
/
1 Way
Remote Start Systems
QUICK START OPERATION GUIDE
NOTE
WINDOW-MOUNT ANTENNA/RECEIVER
Valet / Programming Button
Status LED
PROGRAMMING REMOTES TO THE SYSTEM (UP TO 4)
BEFORE YOU BEGIN: Have all remotes for the system at hand.
1) Turn the ignition key "ON" (do not start).
2) Press the valet button 5 times within 5 seconds of step 1.
- The horn may briefly sound
3) Press & release the "lock" button on each transmitter one after the other.
- 1-button models, press the "start" button.
- The siren/horn may chirp once for each transmitter.
- NOTE: When the fi rst remote is learned all previous remotes are erased.
- NOTE: All other button functions will automatically be assigned.
4) Turn the ignition key "OFF".
SCAN TO WATCH
- NOTE: The system will exit at any time
HOW-TO VIDEO
after 10 seconds of no activity.
1 Button
/
1 Way
Remote Start Systems
QUICK START OPERATION GUIDE
REMOTE START ERRORS
3
CHIRPS/FLASHES
VIOLATED ZONE
LED ON
System in Valet mode
1
Hood opened
2
Brake pedal pressed
3
Bad tach signal or engine over-rev.
4
BLACK/WHITE wire lost ground
5
3D motion detected while cranking
6
Received engine stop command
7
Alarm was triggered
8
Run time expired
9
Low vehicle battery voltage detected
If the system fails to remote start or remote start stops unexpectedly,
it will give a long horn/siren chirp followed by a series of short horn/
siren chirps & light flashes. The short chirps/light flashes indicate
the cause of the failure.
TIP: If remote start won't activate, the system may be in valet mode
(Status LED ON). Press the valet button once to exit.
3-These functions are only available on some remote start models.
3
Advertisement
