Zebratti LCS Series Installation Instruction

Sliding Door Lock
Installation Instructions
Aluminium 40mm Backset
Please note: Dimensions for lock and handles have all clear-
ance
added and all dimensions are set to fit lock easily.
3. File Bottom inside edge of handle cut out to remove
extrusion fins.
20.25
60 °
6. Tighten grub screw to lock handles into place.
9. Align and Centre strike plate opposite the lock latch to
suit engagement, measure the position of the strike plate
from bottom of jamb. Mark and Drill holes for 10g screws
to attach strike plate.
measurement from bottom of
jamb to strike plate
P 09 828 9664 E design2@aesparts.co.nz W zebratti.co.nz
31-33 Timothy Place, Avondale, Auckland
1. Cut out hole for lock in the centre of the stile. (only if
stile is symmetrical.)
LCS
Drill 4mm holes for 10g screws to attach face plate onto
4.
door edge.
4mm
7. Insert Second handle Into frame, following steps 6 and 7
with the driving pin connecting into the Handle.
10. Check lock engagment and use adjustment with
screws if necessary.
2. Cut holes out for handles on either face of the door, this
will be 14mm (critical) above the bottom of lock cut out,
and 20.25mm from the door edge (A).
20.25
20.25
A
R5
Critical
5. Insert rear handle as shown, insert pin (& button on sin-
gle handles) through lock driving block and through to the
handle which opens and closes the lock.
8. Push the euro cylinder lock through lock assembly,
Tighten screw to lock cylinder in place.
11. Place Strike plate cover onto base and adjust with
screws for close fit.
222.5
33.5