Preparations; Using The Remote Control; Setting The Clock - Philips MCM275/98 User Manual

Preparation

Using the remote control

IMPORTANT!
– Remove the
protective plastic tab
before using the
remote control.
– Always point the
remote control directly
towards IR area.
Notes for remote control:
– First select the source you wish to
control by pressing one of the source select
keys on the remote control (for example
CD, TUNER).
– Then select the desired function (for
example ÉÅ , 4 , ¢ ).
To replace the remote controls'
battery
1
Press and hold 1 as indicated
2
Simultaneously, pull the battery tray at 4
3
Remove the old battery and put a new CR2025
battery in place
4
Put back the battery tray
1
CAUTION!
– Remove the battery if it is exhausted
or will not be used for a long time.
– Batteries contain chemical substances,
so they should be disposed of properly.
14
1
2
3
4
5
2
3

Setting the clock

After connecting MCM275 to the power supply,
set the clock first.
In the standby mode, press and hold DISPLAY/
CLOCK on the remote control
➜ SET CLOCK scrolls on the display
➜ 24 HR or 12 HR appears for the initial
clock setting. To select 24-hour clock or
12-hour clock,
●
On the remote control, press VOLUME +/-
once or more (or turn VOLUME on the
set)
●
On the remote control, press DISPLAY/
CLOCK to confirm
➜
The hours digits start flashing
Hold down or press VOLUME +/- repeatedly
to set the hours (or turn VOLUME on the
set)
Press DISPLAY/CLOCK to confirm
➜
The minutes digits start flashing
Hold down or press VOLUME +/- repeatedly
to set the minutes (or turn VOLUME on the
set)
Press DISPLAY/CLOCK to confirm
– To exit without storing the clock setting press
STOP 9
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The set will exit from the clock setting mode if
no button is pressed within 90 seconds.
/
USB