Page 2
Installation Instructions #1) Plug the FlightAware data receiver shown below into one of the USB ports: #2) Connect the FlightAware filter shown below to the FlightAware data receiver using the provided pigtail cable. #3) Connect the FlightAware filter to the antenna using the provided RF cable.
Page 3
#1) On any computer that is on the same network as the Raspberry Pi go to http://flightaware.com/ in the top left corner click on Join FlightAware to register an account or if you already have one then click on Login and enter your credentials.
Page 4
Click on ‘Configure antenna elevation above sea level’, this is a very important step.
Page 5
Next set up your exact location, you can either drag the pointer or input the coordinates.
Page 6
Now you can control your device by sending different commands:...