Preparations; Using The Remote Control; Setting The Clock - Philips MCM239/96 User Manual

Using the remote control

IMPORTANT!
– Remove the
protective plastic tab
before using the
remote control.
– Always point the
remote control directly
towards IR area on the main set.
Notes for remote control:
– First select the source you wish to
control by pressing one of the source select
keys on the remote control (for example
CD, TUNER).
– Then select the desired function (for
example ÉÅ , í , ë ).
To replace the remote controls'
battery (CR2025)
1
Push to open the battery tray.
2
Replace a new battery according to the
indicated polarity.
3
Push the battery tray back to close it.
CAUTION!
– Remove the battery if it is exhausted
or will not be used for a long time.
– Batteries contain chemical substances,
so they should be disposed of properly.

Setting the clock

After connecting MCM239 to the power supply,
set the clock first.
1
Press and hold STANDBY-ON to switch the
set to Standby mode.
➜
The display shows the set time.
➜
-- --:-- -- flashes by default if you have not set
the clock.
2
In the standby mode, press and hold DISPLAY/
CLOCK.
➜ SET CLOCK scrolls on the display.
➜ 24 HR or 12 HR appears for the initial
clock setting. To select 24-hour clock or
12-hour clock,
a. Press VOLUME +/- .
b. Press DISPLAY/CLOCK to confirm
➜
The hours digits start flashing
3
Hold down or press VOLUME +/- repeatedly
to set the hours.
4
Press DISPLAY/CLOCK to confirm.
➜
The minutes digits start flashing.
5
Hold down or press VOLUME +/- repeatedly
to set the minutes.
6
Press DISPLAY/CLOCK to confirm
– To exit without storing the clock setting press
STOP 9.
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The set will exit from the clock setting mode if
no button is pressed within 90 seconds.
Preparation
15