Do you have a question about the GV1000C-STD and is the answer not in the manual?
Questions and answers
Bill
May 7, 2025
What are the reset steps when the code doesn’t work but the keys does?
1 comments:
Mr. Anderson
May 18, 2025
To reset the code on the GunVault GV1000C-STD when the code does not work but the keys do, follow these steps:
1. Open the door using the key. 2. Leave the door open. 3. Find and press the Learn Button for two seconds until the green light appears and a beep sounds. 4. Enter your new code. The green light will stay on. 5. Press and hold the Learn Button again for two seconds. The light turns red and a beep sounds. 6. While the light is red, enter your new code again to confirm it. 7. Press and hold the Learn Button a third time for two seconds, then release it. 8. The light will blink green five times and five beeps will sound, confirming the new code is accepted.
If the red light blinks three times with three beeps, an error occurred. Start over by pressing the Learn Button for two seconds.
This answer is automatically generated
Larry Hopp
March 6, 2025
How do I open my vault if the code no longer works
1 comments:
Mr. Anderson
March 6, 2025
If the code no longer works, you can try using the backup key. Ensure the key number matches the lock cylinder and insert it fully. If the key does not work, you may need to use a flat-head screwdriver by placing it between the body and the door or bang the lower left edge on the ground to help open it.
Need help?
Do you have a question about the GV1000C-STD and is the answer not in the manual?
Questions and answers
What are the reset steps when the code doesn’t work but the keys does?
To reset the code on the GunVault GV1000C-STD when the code does not work but the keys do, follow these steps:
1. Open the door using the key.
2. Leave the door open.
3. Find and press the Learn Button for two seconds until the green light appears and a beep sounds.
4. Enter your new code. The green light will stay on.
5. Press and hold the Learn Button again for two seconds. The light turns red and a beep sounds.
6. While the light is red, enter your new code again to confirm it.
7. Press and hold the Learn Button a third time for two seconds, then release it.
8. The light will blink green five times and five beeps will sound, confirming the new code is accepted.
If the red light blinks three times with three beeps, an error occurred. Start over by pressing the Learn Button for two seconds.
This answer is automatically generated
How do I open my vault if the code no longer works
If the code no longer works, you can try using the backup key. Ensure the key number matches the lock cylinder and insert it fully. If the key does not work, you may need to use a flat-head screwdriver by placing it between the body and the door or bang the lower left edge on the ground to help open it.
This answer is automatically generated