RectorSeal RSH-50 Installation Instructions

Installation
1) To assure proper installation, measure the voltage on each
phase and ensure the correct device is installed.
2) Turn off power to the circuit where surge protector is to be
installed.
3) Mount device to keep conductor length as short as
possible. Cut wires to length and connect to circuit per
wiring diagram below avoiding sharp bends or looping.
4) Reinstall covers, restore power and confirm diagnostic
LED is illuminated.
Device Ratings
Normal Voltage Max. Operating Voltage
Per Leg (MCOV) Per Leg
120 VAC 150 VAC
Para instrucciones en español visite www.rectorseal.com
Technical Support Call 1-800-648-6802
All surge protection devices require a good ground connection for effective operation
Surge Protective Device (SPD) for Single-Phase System
120 VAC DIAGRAM
Single-Phase System: 1 Ph, 2W + G
120 VAC
120 VAC
Max. Discharge
Current (IMAX)
50kA
I N S T A L L A T I O N I N S T R U C T I O N S
120/240 VAC Type 1
240 VAC DIAGRAM
Split-Phase System: 1 Ph, 2W + G
120 VAC
240 VAC
120 VAC
BLACK
GREEN
BLACK BLACK
BLACK
GREEN GREEN
BLACK BLACK
Diagnostic Operations
Diagnostic Operations
Diagnostic Operations
LED ON =
LED ON = LED ON =
System protected
System protected System protected
LED OFF =
LED OFF =
LED OFF =
Replaced Device
Replaced Device
Replaced Device
RSH-50
UL Type 1 SPD
5ME8
240 VAC 2-POLE DISCONNECT
Ground
Green
Black Black