KME A2E7X Manual

Chassis integration with the gigabyte ga-q87tn desktop board

Advertisement

Quick Links

KME A2E7X ALL-IN-ONE PC
CHASSIS INTEGRATION WITH THE
GIGABYTE GA-Q87TN DESKTOP BOARD

1. Removing Rear Cover Fasteners

Remove the four fasteners located at the edge of the rear cover.
If there are 4 fasteners located at the VESA mount points, remove
these as well.

4. Positioning CPU Heat Sink

When positioning the CPU Heat Sink, ensure that it is properly
fastened to the chassis via retention clips on the chassis.

7. Installing Optical Drive

Slide the Optical Drive into position as shown.
10. Removing Rear Stand Rubber Bumper
Peel the rubber bumper back as shown to prepare for rear cover
plate removal.

13. Remove Internal Stand Fasteners

Remove the rear cover and loosen the internal stand fasteners as
shown.

2. Removing Rear Cover

Once the fasteners have been removed, select the lower right or
left side corner and lift the cover upwards.

5. Installing HDD or SSD in Drive Bracket

The 3.5" mounting points in the drive bracket can accommodate a
2.5" drive as shown.

8. Removing Stand Cover Plate

The stand cover plate requires removal as part of the VESA mount
preparation. Remove the four fasteners at the edge of the stand
and one located under the mini-stand extension.
11. Separating Rear Stand Cover Plate Moulding
Separate the rear cover plate moulding as shown.

14. Prepare for VESA mount

Ensure that the rear cover bracket is securely in position and
replace the rear cover as shown. Fasten the 4 outer fasteners
before fastening the four VESA mount fasteners.

3. Removing Rear Cover Bracket

Once the rear cover has been removed, remove the rear cover
plate by shifting it towards the CPU Fan and lifting upwards.

6. Replacing Rear Cover Bracket

When replacing the rear cover bracket, ensure that cables are
properly routed and none are trapped between the cover and
chassis.

9. Positioning Rear Cover Stand Plate

Position the rear stand vertically to prepare for final removal
steps. Please note: Do not extend the stand beyond 90 degrees
as this could cause permanent damage to the stand.
12. Remove Stand Hinge Cover Pate
Unclip the stand hinge cover plate as shown.

15. Attach VESA mount bracket

Position the VESA mount bracket over the four VESA mount points
and fasten the bracket to the chassis.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the A2E7X and is the answer not in the manual?

Questions and answers

Summary of Contents for KME A2E7X

  • Page 1 KME A2E7X ALL-IN-ONE PC CHASSIS INTEGRATION WITH THE GIGABYTE GA-Q87TN DESKTOP BOARD 1. Removing Rear Cover Fasteners 2. Removing Rear Cover 3. Removing Rear Cover Bracket Remove the four fasteners located at the edge of the rear cover. Once the fasteners have been removed, select the lower right or...
  • Page 2 LCD INTEGRATION NOTES 1. Inserting the LVDS Connector 2. Checking Jumper Settings 3. Configuring the BIOS LCD - 5V Navigate to Chipset Select Enable for LVDS Control Function Select M215HGE-L10/M240Q002 for Panel Type FPD - 19V When inserting the LVDS Connector, confirm correct alignment. Confirm that this jumper settings for the Backlight Inverter and Ensure LVDS Cable is Connected Navigate to Chipset...

Table of Contents