Mounting - Busch-Jaeger 0216-101 Manual

Pos: 22 /Busch-Jaeger (Neustruktur)/Modul-Struktur/Online-Dokumentation/Überschriften (--> Für alle Dokumente <--)/2. Ebene/M - O/Montage @ 18\mod_1302615960458_15.docx @ 103424 @ 122 @ 1
5.2

Mounting

Pos: 23 /Busch-Jaeger (Neustruktur)/Modul-Struktur/Online-Dokumentation/Montage/alle Geräte/Montage - UP-Dosen - DIN 49073-1 oder geeignetes Aufputzgehaeuse - Ohne Docvariable @ 20\mod_1325766034453_15.docx @ 136593 @ 2 @ 1
The device may only be installed in suitable flush-mounted sockets (DIN 49073-1) or a suitable surface-mounted
housing.
Pos: 24 /Busch-Jaeger (Neustruktur)/Modul-Struktur/Online-Dokumentation/Montage/Sonstige Bereiche/Montage - Rutenbeck Kompakt-Universal-Anschlussdosen @ 23\mod_1333110834999_15.docx @ 207456 @ 22 @ 1
Fig. 1: Preparing the cable
1. Remove approximately 100 mm of insulation from the cable (see diagonal of the packaging).
2. Push the braid screen back and shorten it by approximately 10 mm.
Fig. 2: Cable feed
3. Feed the cable into the housing at the top or the bottom (in the photo at the bottom).
4. Bend the cable to a quarter circle and feed it in as far as possible.
5. If necessary, adjust the feed-in position (± 30°).
6. Fasten the screw.
Fig. 3: Pre-sorting
7. Pre-sort the twisted pairs.
–
Ensure that you adhere to the hints on the securing webs, which are normally legible (Pos. 2).
8. The upper twisted pairs (Pos. 3) belong to the left socket. The twisted pairs on the left (Pos. 4) belong to the
right socket.
| 1473-1-7878
Mounting / Installation
— 6 —