Advertisement
Installation Instructions – CONTINUOUS & INDIVIDUAL
Important Preinstallation Note:
inaccessible (gypsum board or concealed) ceilings only. For other
ceiling conditions, consult factory. Mounting hardware supplied
by others unless noted otherwise.
RISK OF FIRE AND ELECTRICAL SHOCK
Contact, improper installation, or improper servicing
MAY RESULT IN DEATH OR SERIOUS INJURY!
Fixture must be installed by a qualified electrician only.
Fixture is intended for installation in accordance with
the National Electrical Code, local and federal code
specifications. Disconnect power at electrical panel
before servicing. Retain these instructions for
maintenance reference.
6
Install lens into
extrusion grooves
(snaps in place). Note:
Properly installed lens
is visually equal on
perimeter, and slightly
above extrusion edge within the fixture. Push up the lens
removal tool (located in each end cap) until flush with lens.
a. First disengage one of the lens removal tools at one
end of the fixture from the end cap. Then install the first
lens by snapping one end into the housing and sliding it
until the lens is under the removal tool. Snap the rest of
the lens into the housing.
b. Continue installing
remaining lenses
(except the last one)
by snapping into the
housing and sliding
over to ensure it is
snug with its
neighboring lens.
Zumtobel Lighting, Inc. ©2015
3300 Route 9W
Highland, NY 12528-2630
845-691-6262 • 800-448-4131 • zli.us@zumtobel.com
Part # D00461CI Date 10/06/15 Page 2 of 2
These instructions are for
DA N G E R
specification sheets or other information about our
c. Install the last lens by
attaching the lens removal
tool to one end of the
extruded lens. Snap in
lens with tool, making
sure the lens profile slides
flush into end fixture housing.
For asymmetric lens, install with narrowest grooves
closest to the wall.
For Pattern Configurations
Maintenance -
1) Turn off power first!
2) Contact Zumtobel at (800) 448-4131
To replace LED boards:
1) Do not remove geartrays - Zumtobel offers kits
to replace the LED boards. Contact Zumtobel.
2) Be sure to wear ESD protection!
To replace driver:
1) Contact Zumtobel for authorization.
2) Be sure to wear ESD protection!
WHEN REPLACING PCB ASSEMBLIES, PLEASE WEAR AN ESD
WRIST STRAP AND CONNECT IT TO THE METAL ENCLOSURE.
Questions? Problems? Call (800) 448-4131
and we will be happy to assist you. For technical
products, please go to www.zumtobel.us
SLOTLIGHT LED II
Surface Mount (SM)
For Sheetrock Ceilings Only
ALL LENSES FOR PATTERN
CONFIGURATIONS ARE
SHIPPED OVER SIZE.
INSTALLER MUST MAKE
FINAL TRIM CUT.
LED
Advertisement
