Getting Started; Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The Player; Step 2: Setting The Clock - Philips MCD750/93 User Manual

Getting Started

Step 1: Inserting batteries into
the Remote Control
1
Open the battery compartment.
2
Insert two AAA batteries following the
indications (+/-) inside the compartment.
3
Close the cover.
Using the Remote Control to operate
the Player
1
Aim the Remote Control directly at the remote
sensor (IR) on the front panel.
2
Do not put any objects between the Remote
Control and the DVD Player while operating the
DVD Player.

Step 2: Setting the clock

1
In Standby mode, press and hold CLOCK on
the remote control until the time flashes on the
display.
➜ "CLOCK SET" is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOL clockwise or anticlockwise or press
VOL +/- on the remote control to set the
hours.
3
Press CLOCK to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOL clockwise or anticlockwise or press
VOL +/- on the remote control to set the
minutes.
5
Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.

Step 3: Setting up the TV

IMPORTANT!
Make sure you have completed all the
necessary connections. (See
"Connecting TV").
14
1
Switch the DVD system on and then select DISC
source. (See "Switching the system on/off ").
2
Turn on the TV and set to the correct video-in
channel. You should see the blue Philips DVD
background screen on the TV.
Selecting the colour system that
corresponds to your TV
This DVD Player is compatible with both NTSC
and PAL. In order for a DVD disc to play on this
Player, the colour system of the Disc, the TV and
the DVD Player should match.
1
Press SYSTEM MENU in full stop mode.
2
Press 1 2 to select "PREFERENCE PAGE".
3
Use 1 2 3 4 on the remote to navigate in
the menu.
Move to "TV TYPE" and press 2.
➜
PAL: Select this if the connected TV is PAL
system. It will change the video signal of a NTSC
disc and output in PAL format.
➜
AUTO: Select this if the connected TV is
compatible with both NTSC and PAL (multi-
system). The output format will be in accordance
with the video signal of the disc.
➜
NTSC: Select this if the connected TV is
NTSC system. It will change the video signal of a
PAL disc and output in NTSC format.
4
Select an item and press OK.
Note:
– Before changing the current TV Type setting,
ensure that your TV supports the selected TV Type.
Setting up Progressive Scan feature (for
Progressive Scan TV only)
IMPORTANT!
Before enabling the progressive scan
feature, you must ensure:
1) Your TV can accept progressive signals, a
progressive scan TV is required.
2) You have connected the DVD player to your
TV using Y Pb Pr (see "Connections-Step 3:
Connecting TV- Using Component Video jacks".)
1
Turn on your TV.
2
Turn off your TV progressive scan mode or turn
on interlaced mode (refer to your TV user
manual).