INSTALLATION
Figure 1. BACnet Interface Module, P/N 76-800300-007
Figure 2. BACnet Interface Module, P/N 76-800300-007, with Optional Add-On Module, P/N 76-800300-017
Control Unit
PMU
power (black)
-
AUX2
+
power (red)
-
AUX1
+
+
MCB
J8
(RS232A)
6
5
4
3
2
1
J3
(RS232B)
6
5
4
3
2
1
Earth Ground Stud
Notes:
1. Choose either to connect to BACnet/IP network or BACnet MS/TP network.
2. Maximum length of RS232 cable is 50 ft. (15.2 m)
3. Either AUX1 or AUX2 outputs may be used for power.
4. Either RS232A (J8) or RS232B (J3) ports may be used.
5. Corresponding RS232A or RS232B port must be selected and enabled via
control unit software to allow communication.
6. Installer-supplied RS232 cable must be modified by removing the plug at
one end and stripping wire at that end (module end).
7. If applicable, installer-supplied RS485 cable must also be modified by
removing the plug at one end and stripping wire at that end (module end).
8. Wire stripping should be ¼-in. from end (as shown).
BACnet is a registered trademark of ASHRAE.
Kidde is a registered trademark of Kidde-Fenwal, Inc.
ARIES NETLink is a trademark of Kidde-Fenwal, Inc.
These instructions do not purport to cover all the details or variations in
the equipment described, nor do they provide for every possible contin-
gency to be met in connection with installation, operation, and mainte-
nance. All specifications are subject to change without notice. Should
further information be desired, or should particular questions arise which
are not covered sufficiently for the purchaser's purposes, the matter
should be referred to KIDDE-FENWAL, INC., Ashland, MA 01721.
06-237073-020 Rev AB
©2013 Kidde-Fenwal, Inc.
WIRING DIAGRAM
Enclosure
Power
Terminal
-
Block
RS232 cable
(hardwire module end)
(Ethernet cable)
Ethernet
BACnet Interface Module
Figure 4. Wiring Diagram for standard Single Module
ARIES NETLink™
BACnet
Installation Instructions
400 Main Street
Ashland, MA 01721
Ph: 508.881.2000
Fax: 508.881.8920
www.kiddefiresystems.com
Earth Ground
stud
To BACnet/IP Network
Ethernet cable
To BACnet MS/TP Network
+
RS485 cable
(hardwire module end)
¼ in. (6.4 mm)
Wire Stripping
Effective Date: July 2013
®
Interface Module