T-audio LX200T User Manual

LX200T / R UHF digital tour guide system User Manual
Diagram and lnstructions
LX200T
7
2
8
9
10
3 4 5
Front view Rear view Side view
êp
11
Top view Bottom view
1. Anten na (for LX200T transmitter only)
2. LCD display
3. Down button for channel and volume adjustment
4.
On / Off / Mute / Set button - transmitter
additional function for LX200T: .: to mute the audio signal
On / Off / Set button - receiver
5. Up button for channel and volume adjustment
6. Microphone / Headset input for transmitter
Headphone output for receiver
7. Lanyard connection point
8. Label area
9. Battery compartment and built-in Li-polymer battery
10. Lid of battery compartment and screws
11. Micro-USB charging port
12. Force Shut Down button
Reboot or Restart when the LCD display is Frozen or Stuck
In the unlikely event that your tour guide system becomes frozen and unresponsive, you can attempt
a force shut down and then reboot/restart your guide system.
Follow these steps:
1. Find the "Force Shut Down" button (#12) recessed and located on the side of the device
2. Use a pencil or similar sharp object. Gently press and hold the button for 1 second, then release
the button. The device will turn off. Turn on the device again and confirm that the configuration
has been restored back to the previous settings.
Visit T-audio online: www.t-audio.eu
LX200R
7
2
8
9
12
10
3 4 5
Front view Rear view
�êp
11
6
Bottom view Bottom view
LCD display
CH1,1,t,
lËJOOO
Battery
level
KIIIIIII
Volume
LCD Display lllustration
LX200T transmitter
Mute/Mic disconnect
volume
12
Operating lnstructions
Microphone and Earphone Connection
Side view
Connect the microphone to the 3.5mm socket on the transmitter and the earphones to the 3.5mm
socket on the receiver. Make sure the connectors are properly inserted in place.
Power On and Off
• Press and hold the power button
will illuminate and show the last used channel number to indicate: power on successful.
• Press and hold the power button
power off completed.
Note :
Channel
• Energy saving - receiver will automatically power off if no signal is received for
How to select a channel
The channel is preset to cH f]f]
simultaneously for 2 seconds. The �?�� icon starts flashing. Press
G2:]
channel. Press
seconds to automatically store the selected channel.
Note: Make sure that the transmitter and receiver(s) operate on the same channel. The receiver display
will keep flashing when no transmission signal is being received.
Channel memory
LX200 automatically memorizes the channel number. lt will set to the last used channel
when turned on again.
Channel SYNC - Automatic channel synchronlzatlon between transmitter and receiver
Within the same group, when you change the transmitter's channel number, the receiver's
channel number is wirelessly synchronized to the new channel.
LX200R receiver
Channel change
Mute
Microphone Earphone volume
level 4 level 4
-
No signal received
G2:J
or (§;]for 2 seconds to turn on the system. The LCD display
G2:]
or/(§;] for 2 seconds. The LCD display will turn off to indicate:
I
. If you wish to select a different channel, press
or (§;] button briefly to confirm the selected channel or wait for approximately 55
LX200T / R
LX200T transmitter
LX200R receiver
100% battery remaining
70% battery remaining
30% battery remaining
10% battery remaining
20min.
8
8
and buttons
8 8
or button to select your desired