Download Print this page

Rhyas TURBO MIG 135 User Manual

Table of Contents

Need help?

Do you have a question about the TURBO MIG 135 and is the answer not in the manual?

Page 2 Gas Cylinder Regulator Wire Speed Control Wire-brush/Hammer Welding Mask Overload Light Power Light Power Setting Earth Clamp Mig Wire Welding Torch...
Page 3 Pre-Use & Setup The Rhyas TURBO MIG 135 welder enables the end-user to configure the machine to be used either as a GAS MIG welder or a NO GAS MIG welder. Modifying or incorrectly setting up of the welder could cause permanent damage and invalidate the warranty.
Page 4 Pre-Use & Setup cont…. FITTING THE SPOOL  Unscrew the reel retaining nut from the end of the spool holder and remove the spring.  Slide the unopened reel of wire onto the spool holder.  Refit the spring and the retaining nut, take care NOT TO over tighten the nut. ...
Page 5 Duty Cycle...
Page 6 UK. Subject to change. Document Ref: Rhyas MIG135 Product code:53054 Copyright: These instructions are the sole property of Rhyas and may not be reproduced.
Page 7 MIG 135 Welder 53054 Torch Gas Pipe Tight coiling and uncoiling of the torch lead can cause the gas pipe to detach from the torch trigger so that the welding gas is continuously flowing as opposed to being controlled by the torch trigger, should this occurs it can easily be remedied.