i-tec PCE2S User Manual page 6

EN
1. Turn off the computer and disconnect it from the power supply of 230V.
2. Unplug the power cord and remove your computer's cover. Remove the slot
bracket from an available PCIe slot.
3. To install the card, carefully align the card's bus connector with the selected
PCIe slot on the motherboard. Push the board down firmly. Replace the slot
bracket's holding screw to secure the card.
4. Replace the computer cover and reconnect the power cord.
To Verify Windows
®
Go to the Device Manager (for example, in Win10: the right mouse button
on Start- Device Manager).
You can see new devices under (COM & LPT).
2x PCIe to High Speed Serial Port (COMx)
Note:
• On „PCIe to High Speed Serial Port (COMx)", set Communication Properties
as follows (by the mouse right button-Properties):
• on list Properties -Port Settings set proper Bit per second and other param-
eters; you can change number of COM port also
• next click on list Properties -Advanced – choose type of port RS232 . Click
on „DMA settings" button and choose required settings of DMA access -
OK; next click on „Adv Baudrates.." button and choose either „Use default
baud rate" or „Use custom baud rate" for settings by your requirements. All
settings confirm OK or with help Defaults you return to default settings.
Installation for other OS: Drivers are available here: www.i-tec.cz/en/.
Follow the advices in several driver folders (DOS, Linux) for PCIe (PCE2S).
SAFETY INSTRUCTIONS
• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping and falling
to the ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the ground.
• Check functionality when the cover is broken.
• Send the device back if it does not work in accordance with the user
manual.
FREQUENTLY ASKED QUESTIONS
Available on our website www.i-tec.cz/en on the "FAQ" tab of this product.
6
Quick Start / PCIe to 2S Adapter 2x Serial (PCE2S)
Driver Installation