Table of Contents
Advertisement
Quick Links
THINGS TO CONSIDER BEFORE YOU BEGIN:
it Swiper ID labeled on the back of the swiper and the mounting location (58d6561ed06471f7-Bay 1 or
58d6561ed06471f7-Washer 1). You will need this information when you configure your swiper(s) online. Mount
the swiper with sufficient clearance above and below the swiper to allow a credit card to enter and exit without
obstruction.
Physical Installation – Mount the swiper on the coin box or vacuum. Three holes
1
are required: two for the mounting screws and one for power and signal wires.
Mount the swiper with a vertical orientation. The swiper button must be at the
bottom of the swiper (See Figure 1: Coin Box).
2
Power Wires – Connect 24VAC to the swiper's black and yellow wires. Black Wire:
24VAC Common, Yellow Wire: 24VAC Hot.
Warning: Turn off equipment power before completing this step.
3
Signal Wires – The two red/green striped wires are the signal wires – they are
interchangeable. One will be signal input and the other signal common. The wiring
guide on the back of this page will provide detail for connecting to your timer.
Coin Count Wires* – The two gray wires are the coin count wires – they are
4
interchangeable. One will connect to the coin input of the timer and the other will
connect to the coin common. *Requires CryptoPay Site Analytics. Service
Light Bar – After connecting 24VAC, the light bar on the front of the swiper should
5
become active. If the LED bar is blinking yellow, the swiper is in "Out of service"
mode and must be configured before use.
You are now ready to configure your swipers and coordinator in the
next step of the CryptoPay Quickstart Guide: Online Configuration.
Remember to copy the 16 dig-
CryptoPay
Swiper
Turn over for
more information.
Advertisement
Table of Contents
Summary of Contents for CryptoPay Swiper
- Page 1 Swiper ID labeled on the back of the swiper and the mounting location (58d6561ed06471f7-Bay 1 or 58d6561ed06471f7-Washer 1). You will need this information when you configure your swiper(s) online. Mount the swiper with sufficient clearance above and below the swiper to allow a credit card to enter and exit without obstruction.
- Page 2 Yellow wire to 24VAC hot Requires an external transformer for separate Ginsan One Red/green wire to COIN input 24 VAC power to swiper. 110VAC powered Other Red/green wire to 24vac low Black wire to 24VAC hot of transformer Yellow wire to 24VAC common of transformer D&S DS200/201/...
Need help?
Do you have a question about the Swiper and is the answer not in the manual?
Questions and answers
I am having trouble terminating the red/green wires to Dixmor Led7. One goes to blue wire or pin 9. My pin 9 is a brown wire. The other one it says to terminate to common pin 6 is orange wire and says horn positive. Please help, can't afford to hire anyone. A photo of wires hooked up to Led7 would be great. The yellow and black wires are hot and common. Looking forward to seeing your response.