HASSEB AUDIO OVER ETHERNET PRO Instruction Manual

October HASSEB AUDIO OVER ETHERNET PRO INSTRUCTIONS MANUAL
20, 2018 VERSION 1.0
HASSEB AUDIO OVER ETHERNET PRO
hasseb Audio over Ethernet Pro is an easy to use and portable device used to
send and receive lossless, realtime audio using Ethenet network. The device is
compatible with AES67 standard and can be used as a standalone device or
together with other AES67 compatible devices.
The device operates as a simultaneous stream transmitter and receiver. The
device can transmit and receive analog audio signals using a standard 3.5 mm
audio plugs or digital audio signal using optical Toslink connectors. The device is
configured using a web user interface and mDNS (multicast Domain Name
System) protocol is supported to easily find the device IP addresses from the
network. For professional grade network audio systems PTP (Precision Time
Protocol) based time synchronization is required. The device can act as IEEE1588

Installation

The device is powered through the USB connector using a 5 volts USB power
supply.
DHCP (Dynamic Host Configuration Protocol) support is enabled by default, so
the device will assign an IP address automatically. All Ravenna devices and their
names and IP addresses connected to the network can be found using any
software, capable of searching the network for mDNS supported devices. If you
have normal domestic network router, the web user interface of you router can
also be used to find the IP addresses of the connected devices.

WEB USER INTERFACE

The device can be configured for network, audio, and stream settings using any
web browser. Writing the IP address of the device to the address field of your
web browser, the configuration page will be opened. You can find the IP address
of the device from your network router or using free third party software such as
Bonjour Browser or MT Discovery.
hasseb Inc.
info@hasseb.fi
www.hasseb.fi