Locstar EM 4102 Operation Manual

Technical data Technical data
Technical data Technical data
Card type:EM 4102 card
Read distance ：≤3CM
Work current：Direct current 6V，four pieces AA battery
Static consumption：≤15 uA
Dynamic consumption：300 mA
Work temperature：0℃～70℃
Resist static：＞15000V
Low battery alarm：4.8±0.2，
Door thickness requirement ：35-50MM。
Operation step Operation step
Operation step Operation step
1 1 1 1 、 、 、 、 Set master card Set master card Set master card Set master card
Approach any of new card to the installed new lock,the short buzzer ring refer to master
card has been set successfully.
Clean master card:Press reset button and at the same time approach any of card didn't
set in this lock before,the long buzzer ring refer to the master card has been re-set
successfully.
2.Set unlocking card. 2.Set unlocking card. 2.Set unlocking card. 2.Set unlocking card.
Approach master card in front of lock with a long buzzer ring goes to the condition of
setting unlocking card.During the green ligh flash ,introduce any of ID card ,which didn't
set in the lock before,refer to the main unlocking card has been set successfully with
short buzzer ring.The setting condition will finish within 5 seconds if there is no next card
set
Approach master card in front of lock with a short buzzer goes in to the condition of
setting main unlocking card.Approach master card again within 5 seconds during the
green ligh flash goes in to condition of setting assistant unlocking card.Approach any
of new ID card to set assistand unlocking card with short buzzer ring.The condtion of
O O O O peration manaul peration manaul
peration manaul peration manaul
Reset
button
www.locstar.com
8012 reset
button