Colorado Video MOVERIO DM485CS Quick Start Manual

WARRANTY
Colorado Video, Inc. warrants equipment of its manufacture to be free of defects in material and/or
workmanship under normal use and service. Colorado Video, Inc.'s obligation under this warranty is limited to making
good at its laboratories any part or parts thereof , which shall within thirty (30) days after delivery to the original purchaser
be returned to Colorado Video, Inc. at its laboratories, with transportation charges prepaid, and which Colorado Video,
Inc.'s examination shall disclose to its satisfaction to have been defective.
This warranty is expressly in lieu of all other warranties and representation, express or implied, and of all
other obligations or liabilities on the part of Colorado Video, Inc. In no event shall Colorado Video, Inc. be liable for
damages of any kind connected with the use of its equipment or its failure to function properly.
This warranty shall not apply to any equipment which shall have been repaired or altered outside of
Colorado Video, Inc.'s laboratories so as to, in Colorado Video, Inc.'s judgement, affect its use, function, reliability, or
which shall have been subject to misuse, alteration, improper installation, negligence, or accident.
Before any equipment is returned to Colorado Video, Inc for repairs or adjustments, shipping instructions
should be obtained from Colorado Video, Inc. Colorado Video, Inc. assumes no responsibility for unauthorized returns.
F
CC STATEMENT
This equipment complies with FCC/IC uncontrolled environment radiation exposure limits and meets FCC
radio frequency (RF) OET65 Supplement C and RSS-102 IC Radio Frequency Exposure Rules. Equipment should be
installed and operated at least 7.9 inches away from a person's body excluding extremities.
This equipment complies with limits for Class B digital devices, pursuant to FCC Part 15 rules. These limits
are designed to provide reasonable protection against harmful interference in residential installations. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may
cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment causes interference to radio and television reception, which can be determined
by turning it off and on, the user is encouraged to try to correct the interference by reorienting or relocating the receiving
antenna, increasing separation between equipment and receiver, connecting the equipment to an outlet on a circuit different
form that to which the receiver is connected, and consulting the dealer or experienced radio/TV technician for help.
The connection of non-shielded interface cables to this equipment invalidates its FCC certification and may
cause interference levels exceeding established FCC limits. It is the user's responsibility to use shielded cables with this
device. Do not leave unused cables connected to the equipment. Changes or modifications will void the user's authority to
operate the equipment.
www.colorado-video.com
Using the Video Interface.
TM
1. Connect your Moverio BT-200 Smart Glasses directly to the
TM
"Moverio " connector on the Video Interface. Epson's Moverio
controller is not required for using the Video Interface.
2. Connect your video source to the mini-HDMI "Video In"
connector.
3. Connect a high quality USB power source with a micro-USB
cable to the "USB+5" connector.
4. Adjust picture brightness as desired by using the "Brightness +"
and "Brightness -" buttons.
5. Toggle the picture On/Off by pressing the "Hide" button.
Avoid prolonged exposure to direct sunlight or other heat sources.
TM
MOVERIO
Video Inte rface
DM485CS
SN:
TM