Subscribe to Our Youtube Channel
Summary of Contents for Vaderstad ISOBUS
- Page 1 ISOBUS Task Controller Quick Start Fendt VarioTerminal 10.4 Terminal Software: 781 903114, 2017-01-25 1...
- Page 2 Denna Quick Start ersätter inte instruktionsboken! See kiirjuhend Quick Start ei asenda kasutusjuhendit! Denne Quick Start erstatter ikke instruktionsbogen! Návod Quick Start nenahrazuje návod k použití! Denne Quick Start erstatter ikke instruksjonsboken! Ez a Quick Start útmutató nem helyettesíti a Használati útmutatót! Tämä...
- Page 3 1 (5) Väderstad ISOBUS implement with Fendt VarioTerminal 10.4” Issued by Date Edition Niklas Rosén 2017-01-25 Väderstad ISOBUS implement with Fendt VarioTerminal 10.4” NOTE! This document is a quick guide only and requires that the Väderstad implement is connected correctly and that the user possesses some basic knowledge of how this display and it´s functions is working.
- Page 4 Fendt VarioTerminal 10.4” 1. Introduction When installing and running a Väderstad ISOBUS implement with a ISOBUS terminal, it is important to follow and complete the steps in this guide. This document is a quick guide only and requires that the Väderstad implement is connected correctly to the display and that the user possesses some basic knowledge of how this display and it´s functions is working.
- Page 5 3 (5) Väderstad ISOBUS implement with Fendt VarioTerminal 10.4” 3. Check Activations In order for “Section Control” and/or “Variable Rate” to work the display must be unlocked with a specific license. If the display is locked, please advise your local display reseller in order to purchase this activation.
- Page 6 4 (5) Väderstad ISOBUS implement with Fendt VarioTerminal 10.4” Screen 3. Task Controller ON Once the Task Controller is set to “ON” a new implement will be detected by the display. From the general settings, press the “TC-submenu” button. In this menu you´re telling the display what product to be controlled and also what functions to be used by turning “Section Control”...
- Page 7 5 (5) Väderstad ISOBUS implement with Fendt VarioTerminal 10.4” 6. Create job and/or enter necessary documentation settings If VarioDoc is to be used in order to do documentation of the work being performed, please see chapter 4, “VarioDoc usage (35)” in the VarioDoc operators manual.
- Page 9 Väderstad AB SE-590 21 VÄDERSTAD Phone: +46 142-820 00 www.vaderstad.com...
Need help?
Do you have a question about the ISOBUS and is the answer not in the manual?
Questions and answers