Summary of Contents for Argos G03131P
- Page 1 Stainless Steel PIR Lantern G03131P Care & Instruction Manual Please read and retain these instructions for future reference Issue 1 25/2/2019...
- Page 2 This light fitting must be installed in accordance with the Institution of Electrical Engineers (BS 7671) Wiring Regulations and the current Building Regulations. If in any doubt consult a qualified electrician. WARNING If in doubt about the installation of this light fitting or difficulty is experienced consult a qualified electrician.
- Page 3 Selecting a location 1. Select a suitable location for your lantern where it will not cast heavy shadows, obstruct headroom or any outward opening doors. 2. Avoid positions that are exposed to very heavy rain or snow. 3. Ensure that there is sufficient space above the lantern to be able to unscrew and remove the glass cover.
- Page 4 Securing the light fitting to the wall Isolate the lighting circuit to be used and remove the circuit fuse or switch off the circuit breaker at the consumer unit (fig.1). Remove any existing light fitting from the wall. Unscrew the domed nuts and separate the back plate from the light fitting.
- Page 5 Using the point of a brad awl or screwdriver, make a small hole in the centre of the cable grommet and feed the cable and insulation through the grommet (fig. 4). Check the fixing bolts are still in position, before securing the back plate to the wall using the screws supplied (fig.
- Page 6 Connecting to the mains supply Connect this unit to a lighting circuit protected by a 5-Amp fuse or 6- Amp miniature circuit breaker. If this unit is to be connected to a ring main, a fused connection unit fitted with a 3-Amp fuse should be installed.
- Page 7 Any existing mounting plate or rose must be removed before installing When installing, a ‘loop in’ wiring system may be this fitting. encountered. If these are encountered, the wires from the existing rose or loop must be transferred to the terminal block as per the diagram below.
- Page 8 Fitting and replacing the bulb (not included) 1. Switch off the lantern and allow the fitting to cool completely. 2. Carefully unscrew the glass cover and place to one side (fig. 8). Take care of the glass cover supplied, as replacements are not available.
- Page 9 Motion detector range The PIR detects heat or movement in a fan shaped arc of approximately 110˚ for a distance up to 7 metres. The detection distance will depend on the installation height and the weather conditions. Each time movement is detected the lamp will illuminate.
- Page 10 Activation light level The sensor can be set to activate whenever heat or movement is detected (irrespective of daylight level) or only to operate in the hours of darkness. Adjust the right hand control using a flat head screwdriver. Turn knob fully anticlockwise for the sensor to operate in daylight.
- Page 11 Do not use abrasives as these may scratch the surface and NEVER use a wet cloth or immerse in water. Technical specification Cat No: 8848628 Model G03131P Rated voltage 220 - 240V ~ 50Hz Class rating 1 (earthed) Max 60W ES GLS...
Need help?
Do you have a question about the G03131P and is the answer not in the manual?
Questions and answers