Hawking Hi-Gain HD9DP Quick Installation Manual

Part No. HD9DP
Start Here

Use the HD9DP to expand the wireless range of your router, bridge, access
point, or extender.
Package Includes
1. HD9DP Directional Antenna
2. Anchor Nuts (3)
3. 5/8" Self Tapping Screw (2)
4. 5/16" Self Tapping Screw (1)

Connecting the Antenna to your Wireless Device
Reset/WPS
Radio
On/OFF 5 4 3 2 1 Power
A. Remove the antenna
from your wireless
device

Position Your Antenna
After you have connected your HD9DP to your wireless device, make sure to note the signal pattern of the ontenna. Be sure to face the side of the
antenna with the Hawking Logo at your wireless device(s). While you will experience superior range and quality with your HD9DP , you must be in range
of the antenna's signal. As indicated by the diagram at the right, the directional antenna does not give off signal from the back of the product. You will
receive optimal wireless signal by placing your wi-fi device within the designated area. Adjust the antenna as needed. (NOTE: Your wireless coverage may
vary depending on the receiving power of your wireless adapter.)
Technical Support | Toll free US & Canada: 1.888.202.3344
HW2R1 rev 1 I QIG v.20101118
Hi-Gain Dual-Band 9dBi Directional Antenna Kit
TM

1
B. Connect your Antenna
Cables to the antenna ports
on your device.
QUICK INSTALLATION GUIDE
2 3 4
| Email: techsupport@hawkingtech.com
Wireless Hot Spot
System Requirements
(not included)
• Wireless Networking Device with
Removable Antennas
• Screw Driver/Drill for Wall
Mounting Option
NOTE: If your device has only one
removable antenna port, you can
plug in the pigtail wire of your
choice. If your device has two ports,
use both pigtail plugs.
Technical Support: 1.888.202.3344
© 2013 Hawking Technologies, Inc. All rights reserved.
HD9DP V1.QIG 20121205
www.hawkingtech.com