Advertisement
WEEKLY MAINTENANCE
1. When checking the coolant level briefly turn the heater on to ensure correct operation.
Remember that under racing conditions water can be pushed out of the cooling system
causing air pockets.
GENERAL TIPS
• Ensure that the P1 engine heater has a stable power supply source. Unstable power supply
can cause internal damage to the unit.
• If the heater gets hot very quickly after start up, switch off immediately to prevent further
damage. The possible cause is air in the system.
• Ensure that the P1 engine heater is operated periodically during the offseason to ensure
correct operation is maintained. Failure to operate could cause pump failure.
• DO NOT operate P1 engine heater prior to being connected to a cooling circuit. If power is
applied to unit without being connected DAMAGE WILL OCCUR!
• Ensure that the P1 engine heater is protected from water. This is an electrical device and
any external water entering the unit may cause failure.
200 SERIES REMOTE ENGINE HEATER
www.p1australia.com
Advertisement
