Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not use old and new or different types of batteries
in combination.
•
Batteries contain chemical substances, so they should
be disposed of properly.
Connect power
Caution
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the rear of the main unit.
•
Before connecting the AC cord, make sure that you
have completed all other connections.
Note
•
The type plate is located on the rear of the main unit.
1
Connect the AC power cable to:
the AC MAINS connector on the rear
•
of the unit.
•
the wall socket.
Store DAB stations
When you connect AC power and no DAB
stations are stored, the unit prompts you to
search and store all the available DAB stations.
1
Connect the unit to the power supply.
» [FULL SCAN](full scan) is displayed.
2
Press OK to start to search and store
DAB stations.
» The unit stores all the available DAB
stations.
» When all the available DAB stations
are stored, the first stored DAB station
is broadcast.
Note
•
Position the antenna as far as possible from TV, VCR, or
other radiation source.
•
For optimal reception, fully extend and adjust the
position of the antenna.
Set clock
Note
•
You can set the clock in standby mode only.
1
Press
to switch the unit to standby.
•
Make sure that --:-- (or clock) is
displayed (see "Turn on" > "Switch to
standby").
2
Press and hold PROG/CLOCK SET to
activate the clock setting mode.
» SET CLOCK is displayed.
» The 12 hour or 24 hour format is
displayed.
3
/
Press
to select 12 hour or 24
hour format.
4
Press PROG/CLOCK SET.
» The hour digits begin to blink.
5
/
Press
to set the hour.
6
Press PROG/CLOCK SET.
» The minute digits begin to blink.
7
/
Press
to set the minute.
8
Press PROG/CLOCK SET to confirm.
EN
11