Safety Warnings - GRE POOL EXPERT PLCH144 Instruction Manual

Then, assemble the floodlamp in the opposite order of that described. Make
sure that the butt joint and the transparent lens are inserted properly in the
screen seat.
Align the word "TOP" on the ornament with the word "TOP" on the screen
fastening.
Turn the ornament slightly to the right until it is fitted with the screen.
Wind 1..5m of cable in counter-clockwise direction under the screen fastening
clamps. (Fig 5)
Attention:
 Before any handling ensure that there is NO voltage supplied to the
floodlamp.
 The new lamp should have the same characteristics as that supplied with
the floodlamp, (75W 12V halogen lamp).
 In order to ensure full watertightness, clean the seat of the floodlamp lens
joint or replace this if any permanent deformation or notches are visible.
6. START-UP:
Ensure that the voltage the lamp receives is never greater than 12 V.
The floodlamp should only operate underwater while secured to the vertical
walls of the pool. Never switch on the floodlamp if it is not underwater.

8. SAFETY WARNINGS:

 The people who are in charge of assembly should have the required
qualificatlons for this type of work.
 If the end cable of this light fitting is damaged, it should only be
replaced by the manufacturer, its technical service or by a similarly
qualified person, to avoid any danger.
 Avoid making contact with the electric voltage.
 Comply with the current standards regarding accident prevention.
 In this regard, the IEC 364-7-702 standards must be observed.
WIRING IN BUILDINGS. SPECIAL WIRING. SWIMMING POOLS.
 Any operation related to the maintenance or replacement of parts
should be performed with the floodlamp disconnected from the electric
power system.
 Do not handle with wet feet.
 The
manufacturer
assembly, installation or start-up of any electric components which have
been inserted or handled at locations other than Its own premises.
is not responsible in any circumstances for