Advertisement
3.
Installation and clearing of filter
After soaking of cartridge, place it in a
container for untreated water, intended for his
place and make sure it is flat against the wall.
Then place a tank for untreated water over
container for purified water.
Remove a top cover, pour water into the tank
for untreated water, filling it completely. Let
water pass through filter cartridge. Repeat
procedure 2 times. Then wash cartridge.
Please do not drop a cartridge to tank for
treated water.
5.
Notice
During the first use of a cartridge, purified water can be gray in color, this is due to the
activation of activated carbon in toner cartridges. This is normal and it will pass after a
single 2-filtration cartridge. Do not use water that has been used for filtration cartridge for
drinking, it is suitable for domestic use.
1. Limit of the filter capacity is 1.5 l. While adding water, please make sure that water
does not extend beyond this limit.
2. If water pressure is insufficient to activate an automatic shutter, in this case, open it
yourself.
3. To ensure thorough disinfection of water UV light will burn for 2 minutes.
4. UV LED lights up only when quartz tube disinfection device will be completely
immersed in water.
5. Disinfection device can only use water that meets the «Sanitary norms of drinking
water» (gb5749-2006), please do not use it for other purposes.
Quick start
4.
Turning indicator of life of a cartridge
Hold start button for 3 seconds until a light
turns on, then release a button. Since then
count out the lifetime of a cartridge.
Operating Instructions
Adding water
Through the hole for pouring water add
a water from the tap to tank for untreated
water.
Disinfection
When water not yet reached the level of
UV lamp, press a button to turn the UV
disinfection. After 2 minutes, it automatically
expires. You can just use water.
Filtration
Completely fill a tank for untreated water
(1.5 L), then water will flow through the
cartridge filter and fall into tank of purified
water.
Charging UV disinfection device
Connect micro-USB to a battery of
ultraviolet disinfection device. During
charging, indicator will light red, and when
battery is fully charged, indicator light turns
blue.
Note: Do not use a filter during charging.
Advertisement
