Table of Contents
Advertisement
Available languages
Available languages
W-MBus Modems/Receiver/Repeater - Guide utilisateur / User guide version V1.8.2
8.2.2 Wireless M-Bus repeater AMR (battery)
The battery repeater can repeat all Wireless M-Bus frame, provided they conform to EN13757 standards and that the transmission mode is T1
mode.
The battery repeater is configured to listen to a daily 4 min and 10 seconds , by default
Under these conditions, we can use a few dozens of transmitters per repeaters maintaining a long life
FR
Battery type
Li-SOCl2
Li-SOCl2
9. Wireless M-Bus Receiver AMR
EN
The Wireless M-Bus Receiver AMR (Automatic Meter Reading) from adeunis® is a ready-to-use system allowing to receive consumption data
from Wireless M-Bus transmitters AMR or Wireless M-Bus repeater AMR.
This receiver can acquire Wireless M-Bus frames and transit them to any collection device and / or operating data with a RS232 or RS485 serial
port.
At first switch on, by default, the AMR RECEIVER is set to : T1 «Other».
Serial port parameters : 115.2kbps / 8bits / no parity
The Product is ready to use without any configuration needed.
9.1. Technical specifications
9.1.1 Products
Name
Wireless M-Bus receiver AMR (RS232)
Wireless M-Bus receiver AMR (RS485)
Wireless M-Bus receiver AMR (USB)
9.1.2 General characteristics
Parameters
Serial port data rate
Power supply
Operating temperature
Dimensions
Case
Standards
9.1.3 Radio characteristics
Module type
Wireless M-Bus
9.2. Implementation of Wireless M-Bus receiver AMR
9.2.1 Wireless M-Bus receiver AMR RS232
By default, the receiver is configured for T1 mode. Simply connect power and serial port and all T1 Wireless M-Bus frames will be transmitted on
the RS232 serial link (frame format is described in the User Module Guide Wireless M-Bus is available on the website adeunis®
).
com
To enter command mode and change the configuration, simply activate the RTS (User Guide Module Wireless M-Bus).
Mode
Daily repetition
T1
250 sec (4mn and 10 sec)
T1
Reference
ARF7922BA
ARF79222CA
ARF7922EA
Value
115.2kbps (8N1)
Main through provided power supply
-40°C / +85°C
145 x 100 x 40
IP 65
EN 300-220, EN 301-489, EN 60950, EN 13757-3 et EN 13757-4
RF power
Sensitivity (if RX adeunis®)
14dBm (25mW)
-110 dBm mode T1
Autonomy
180 sec (3mn)
Firmware version
V1.0
V1.0
V1.0
Reference
8 years
ARF7924AA
10 years
on demand
data rate
Range
100 kbps
-
www.adeunis.
Page
48
of of 50
Advertisement
Table of Contents
