Otter Legend 800 Operating Instructions & Maintenance Manual

L
L
egend
egend
Powering garden ponds since 1968
Powering garden ponds since 1968

ELECTRICAL CONNECTIONS

The pump comes complete with 10 mtrs of 3 core cable, however, should any additional
cable be required then the use of an approved waterproof cable connector is essential.
Ÿ
The power supply must be earthed and fused at 3amps.
Ÿ
Regularly inspect the cable for damage and deterioration
Ÿ
Always use a residual circuit device (RCD) for additional safety
Ÿ
For permanent installation to the mains supply, it is necessary to comply with the
regulations of the Local Electricity Authority.
Ÿ
Consult a qualified electrician if in doubt about any aspects of wiring.

SAFETY

Ÿ
Always disconnect
SAFETY
installation/maintenance or handling of any kind.
Ÿ
The pump should never be run dry as this will cause the unit to overheat and damage it.
Ÿ
Do not attempt to modify this unit in any way and only use the recommended parts for
replacement.
Ÿ
Do not place in liquids other than water.
Ÿ
All connections must be Earthed.
Ÿ
Do not connect to any voltage other than that stated on the pump.
Ÿ
Do not use in water above 90°f / 30°C.

INSTALLATION

The pump should be sited on a firm base, raised from the bottom of the pond. Connect a
suitable length of hose pipe if required. It is important to cut the multistage hose
connectors to the correct size to fit hose pipe.
Otter Legend 800
Operating Instructions &
Operating Instructions &
Maintenance Manual
Maintenance Manual
K I T
K I T
the mains
Otter Legend
1500 - 6000
NEUTRAL = BLUE N
EARTH = GREEN & YELLOW
LIVE = BROWN L
electricity supply
Open
Side Outlet Operation
Flow Control for
Fountain
before attempting
Flow Adjuster Operation
Closed
Open
Closed
any