AUX/ UPnP/SLEEP
AUX (Listening to an external
source, on Center only)
You can listen to the sound of the connected
external device through your WAC5 Center.
1
Check the external device has been properly
connected (See Installation, Connecting an
additional appliance)
2
Check the WAC5 Center is switched on or to
standby (See Basic functions, Switching on/
to standby and selecting functions,
Switching to Eco power/ on)
3
Press SOURCE once or more to select AUX
(on the remote control, press TUNER/AUX)
4
Press the PLAY key on the connected device to
start playback.
5
To adjust the sound and volume, use the sound
controls on your external device
38
UPnP (on Station only)
After connecting your WAS5 to an existing
network, you can set up a UPnP* server in the
network. Play from your WAS5 stations the
music collection either on the Center or on the
UPnP server.
*
Univeral Plug and Play (UPnPTM) builds on
standard networking technologies and provides
standardized protocols for a wide variety of
home and small business devices. It allows easy
interoperability of all the devices supporting the
the networking technologies.
Requirements for the UPnP server:
●
The UPnP device has been connected to the
same network as WAS5.
●
UPnP server software is installed (e.g. Philips
Media Manager, Musicmatch® ) and the UPnP
server function is enabled.
– With Philips Media Manager, the UPnP server
function is enabled by default.
To connect a UPnP server
If the WAS5 Station is now connected to
Center,
1
Check the Center is switched on or to standby
mode
2
Check your UPnP-enabled PC is switched on
– Switch off your firewall
3
Switch on the Station
4
To select Select Server on Station
a. On the remote control, press MENU.
b. Use the navigation controls 3 or 4 and 2 to
select
➜
The Station 's display shows the list of servers
connected
➜
Server not found appears if there is no
UPnP server in the network
5
Use the navigation controls 3 or 4 and 2 to
select your desired server
➜
The Station 's display shows PC's music as
it does on PC
If the WAS5 Station has ever been
connected to Center, but is now
disconnected from Center
1
Connect WAS5 to the power supply
➜
Display shows: "Connecting to Center..."