Philips WAS7000/05B User Manual page 42

15.Troubleshooting
Problem
Stations react when you operate the
Center's remote control
The remote control does not function
properly
Sound cannot be heard or is of poor
quality.
Some files on the USB device are not
displayed
Radio reception is poor
There is interference on the radio
reception whenever the Station is near my
PC
How do I mount the Station
onto walls?
Upgrading Station wirelessly failed.
42
Solution
✔ The remote control for the Center is powerful
enough to operate several Stations within a certain
distance or angle. Check that you have placed the
Stations in different rooms or place them at
different angles
✔ Use the remote control for the Station or the
controls on the set.
✔ Reduce the distance between the remote control
and the set.
✔ Insert the batteries with their polarities (+/– signs)
aligned as indicated.
✔ Replace the batteries.
✔ Point the remote control directly towards the IR
sensor.
✔ Adjust the volume.
✔ Disconnect the headphones.
✔ Switch off MUTE.
✔ Check if the number of folders exceeds 99 or the
number of titles exceeds 999.
✔ Only completely recorded MP3/WMA files can be
found and played by WAS7000. Check if the file
has been completely recorded.
✔ DRM-protected WMA files cannot be played on
WAS7000.
✔ If the signal is too weak, adjust the antenna or
connect an external antenna for better reception.
✔ Increase the distance between the set and your TV
or VCR.
✔ Install the supplied FM wire antenna for better
reception.
✔ Keep the Station at least 1 meter away from your
PC.
✔ Use the by-packed wall mounting kits. It is
recommended that you get a qualified personnel
to fix the mounting brackets safely onto your walls
before you mount the or Station. For details, refer
16.1
to : How to mount your Station onto Walls.
✔
Upgrade the Station via ethernet cable following
steps below:
1. Connect the Station to your PC via the supplied
ethernet cable and power on the Station.
2. Download the firmware upgrade file specified
for station.
3. Launch WADM and click Firmware upgrade.
4. Follow the on-screen information to complete
the rest steps.