Advertisement
Quick Links
Advertisement
Summary of Contents for Steltronic Universal LCD Mounting Bracket
- Page 1 Steltronic Universal LCD Mounting Bracket Assembly...
- Page 2 Components necessary to build the bracket assembly A. Main Plate (1 required per pair of monitors) B. Slide Rails (2 required per pair of monitors) C. Monitor Plate (2 required per pair of monitors) D. Channel Assembly (2 required per pair of monitors) E.
- Page 3 F. Shelf Plate (1 per pair of monitors) • Note: This shelf plate is only necessary when installing the Vision Lane Computers, as the Elex and Super Elex have different mounting systems G. VLC Mounting Plate (2 required per pair of lanes, and you should have one left and one right side) •...
- Page 4 Assembly instructions for the Steltronic Universal LCD Mounting Bracket Assembly of the Steltronic universal bracket assembly is not difficult, but there are a few tips below that will help you assemble this bracket assembly correctly the first time without the need to go back and make fine tuning type adjustments.
- Page 5 • Step 3: Mount the long slide rails (part “B”) to the plate (Part “A”), and when you do this, the rails get bolted to the front side of this plate. Take note of how the plate is resting in the image below, because you need to mount the slide rails to the “front”...
- Page 6 • Step 4: Mount the monitor plates (Part “C”) to the back side of the LCD monitors. When you do this, it’s important to keep all of these plates mounted on each monitor in the exact same way for each monitor. We suggest keeping the monitor plate (Part “C”) loose on the monitor, then pushing this plate down towards the bottom side of the monitor, and then to the far left of the monitor before you tighten the hardware.
- Page 7 • Step 5: Locate the Channel (Part “D”) and install this to the back side of monitor bracket assembly. o There are many holes across the main plate (Part “A”) that you can use for adhering to the existing chain and/or cables coming out of your ceiling. •...
- Page 9 DO NOT OVERTIGHTEN the hardware that secures the hanger into the channel, as this will make it very hard to remove the hanger from the channel. The cap screw and locknut should only be tightened until the locknut BARELY touches the channel. o The cap screw that holds the chain or aircraft cable into the hanger can be placed into any of the holes provided, and by using different holes;...
- Page 10 • Step 7: Install the LCD monitors onto the frame assembly, and we suggest you mount all monitors to the frame assembly on the ground first. The reason for this is; the monitors are at ground level and can be fine-tuned (straightened out), with all hardware finally tightened to secure the monitor from being lifted off the frame.
- Page 11 The monitor plate (Part “C”) above is used with any LCD monitor that supports the VESA standard bolt patterns. If you have purchased Hantarex LCD monitors, the adapter plate shown below will need to be installed.
- Page 12 Step 8: When you place the lane computer onto the monitor frame (Part “A”) assembly, the lane computer can be installed easily with the plates supplied by Steltronic. o If you need to mount a Vision Lane Computer onto the monitor frame, using (Part “G”), install the plates as shown below.
Need help?
Do you have a question about the Universal LCD Mounting Bracket and is the answer not in the manual?
Questions and answers