Advertisement
! Warning:
Confirm the correct connection method,
incorrect connection can lead to improper work,
and even damage.
If install wrong, it may fall off.
Refer to installation instruction for installing.
一.
Basic Parameter：
1. Source type: LED
2. Protection Grade(IP):IP67
3. Rated Voltage: AC220V
4. Appliance Grade: Class I
5. Dimension: see figure 1
Diameter(mm)
Power（W）
Ø260
Figure 1 LED Dimension
LED INGROUND LIGHT
INSTRUCTION
N.W.(kg)
40W
5.50
二
.
Observe the following dos and don'ts
1. Install in the IP 67 environment or beneath the IP67.
2. Prohibit punching any position of lamps
3. Please turn off the power and contact the dealer for problems in connection or
other abnormal cases.
4. Installed by the qualified
electrician holding a certificate.
5. Prohibit operating the lamps beyond the voltage scope as nation stipulated
6. Don't make the external power cable exposed during wring.
三.
Installation Instructions
1. According to figure2, laying 20cm or much deeper water-seepage sand
in the mounting hole before installing the buried barrel.
Figure 2 Diagram of laying the sand
Rundit
14126
Advertisement
Table of Contents
Summary of Contents for SYV design Rundit 14126
- Page 1 Rundit 14126 LED INGROUND LIGHT INSTRUCTION 二 Observe the following dos and don'ts ! Warning: Confirm the correct connection method, 1. Install in the IP 67 environment or beneath the IP67. incorrect connection can lead to improper work, 2. Prohibit punching any position of lamps and even damage.
- Page 2 2. According to figure 3, install the buried barrel 4. According to figure 5, fix the buried barrel and lamp body by screws Figure 3 Diagram of installing the buried barrel Figure 5 Diagram of fixing the LED inground light 3.
Need help?
Do you have a question about the Rundit 14126 and is the answer not in the manual?
Questions and answers