Advertisement
Quick Links
Installation
Lubricate the frame sparsely on
the outside black rubber part with
Roxtec Assembly Gel.
Adapt modules which are to hold
cables or pipes by peeling off
layers until you reach the gap seen
in pic. 5b.
Push the front fittings back towards
the centre.
Lubricate the inside faces of the
frame thoroughly, especially into
the corners.
Achieve a 0.1-1.0 mm gap between
the two halves when held against
the cable/pipe.
Approx. 8 mm/0.315"
Tighten the nuts.
Max torque is 4 Nm/2.95 lbf·ft.
Installation Instructions
Roxtec CRL 4" and 5"
Insert the frame into the sleeve
opening.
Lubricate all modules for the frame
thoroughly, both the inside and the
outside surfaces.
Excess Roxtec Lubricant will
protrude when tightening the seal.
Loosen the nuts and push the front
fittings to the sides.
Insert the modules in the frame.
The installation is complete.
Advertisement
Summary of Contents for Thorne & Derrick Roxtec CRL 4"
- Page 1 Installation Instructions Roxtec CRL 4" and 5" Installation Lubricate the frame sparsely on Lubricate the inside faces of the Insert the frame into the sleeve Loosen the nuts and push the front the outside black rubber part with frame thoroughly, especially into opening.
- Page 2 Disassembly Reverse order Note For optimum reliability, wait 24 hours or longer after installation before exposing the cables/pipes to strain or pressure. Cables/pipes shall be routed perpendicularly to the wall. Roxtec CRL kits For 1 cable Module (mm) For cable diameter (in) CM 66 0+24-54...
Need help?
Do you have a question about the Roxtec CRL 4" and is the answer not in the manual?
Questions and answers