Advertisement
3
Input:
120-277V for UL,
220-240V for CE
0.82 - 1.5 mm
2
(18 - 14 AWG)
8~9 mm (0.31~0.35 in)
0.40 - 0.50 Nm
4
At least one GROUND connection needs to be connected to Earth or
screwed GPS or 2G/3G antenna is connected and installed on cabinet
Hereby, Signify declares that the radio equipment type
LCN7700 is in compliance with Directive 2014/53/EU. The
full text of the EU declaration of conformity is available at
the following internet address: www.philips.com/red
© 2018 Signify Holding. All rights reserved. Specifications
are subject to change without notice. No representation
or warranty as to the accuracy or completeness of the
information included herein is given and any liability for
any action in reliance thereon is disclaimed. Philips and
the Philips Shield Emblem are registered trademarks of
Koninklijke Philips N.V. All other trademarks are owned by
Signify Holding or their respective owners.
4422 409 43453
RS232
USB*
ETH**
GPS
2G/3G
(RPSMA
(SMA
female)
female)
2x A: 0-10V,
0-20mA
(Analog input
impedance is 510ohm)
1x D: Connect terminal to
GND for a digital low.
0.14 - 0.5 mm
2
(26 - 20 AWG)
5 mm (0.2 in)
0.20 - 0.24 Nm
27 December 2018
ABUS:
0.14 - 0.5 mm
RS485
12V/460mA
(26 - 20 AWG)
ABUS
5 mm (0.2 in)
0.20 - 0.24 Nm
Leakage
Phase
current:
current:
1-15mA
1-100mA
Relay:
Max 277V for UL,
Max 250V for CE,
3A (resistive)
0.82 - 1.5 mm
2
(18 - 14 AWG)
6 mm (0.24 in)
0.40 - 0.44 Nm
2
Open
0.14 - 0.5 mm
2
(26 - 20 AWG)
5 mm (0.2 in)
DALI
0.15 - 0.20 Nm
* Provides2x250mA USB 2.0
host ports totally
** support shielded
Ethernet interface
10/100M Automatic
5
NO 1
COM 1
NC 1
Switch connection
www.philips.com/lighting
Micro-sd
card
Micro-sim
card
COM 2
NO 2
Advertisement
