Download Print this page

Gatekeeper Designs GC3-A Manual

Chassis kit for the axial ax-10 rock crawler

GC3-A Chassis Kit

For the Axial AX-10 Rock Crawler

Disassembly of the stock AX-10 kit is required.

Parts Included:

Chassis side plates (2)

Steering servo plate (1)

Rear axle/link plate (1)

20° bent lower rear links (2)

Lower front links (2)

Rear upper links (2)

Front upper links (2)

Lower shock mount spacers (2)

Rear upper link mount spacers (2)

Center chassis brace/upper shock mounts (4)

Rear upper shock mount spacers (2)

Front upper shock mount spacers (2)

Chassis skid plate (1)

Rod ends (16)

Rod end balls (16)

3x8mm Button head machine screws (6)

3x14mm Button head machine screws (4)

3x16mm Button head machine screws (2)

3x27mm Button head machine screws (2)

3x25mm Button head machine screws (8)

3x35mm Button head machine screws (2)

3x14mm Flat head machine screws (10)

3mm Nylon lock nuts (12)

3x6mm Flat washers (2)

3x16mm Set screws (16)

3x10mm Flat head machine screws (2)

Table of Contents

Do you have a question about the GC3-A and is the answer not in the manual?

Page 1 GC3-A Chassis Kit For the Axial AX-10 Rock Crawler Disassembly of the stock AX-10 kit is required. Parts Included: Chassis side plates (2) Center chassis brace/upper shock mounts (4) 3x27mm Button head machine screws (2) Steering servo plate (1) Rear upper shock mount spacers (2)
Page 2 Phillips screwdriver (DTXR0122) Needle nose pliers (DTXR0300) Threadlock (DTXR2010) 4. Mount your AX-10 transmission to the GC3-A skid plate using four 3x14mm ﬂ at head screws. Note: Notice the direction of the transmission on the skid plate. 1. Install four ﬂ anged rod end balls into the rod ends. Install four 3x16mm set screws into the rod ends.
Page 3 7. Install the upper links to the chassis using four 3x14mm button head screws and four 3mm lock nuts. Note: The longer upper links go in the rear. The upper links mount to the outside of the chassis as shown. 10.
Page 4 13. Install your steering servo onto the steering servo plate. Secure 16. Attach the rear axle plate to the rear axle using two 3x14mm ﬂ at the servo to the servo mounts using the servo mount screws from head screws and one 3x10mm ﬂ at head screw (see pic.) your AX-10 kit.