Table C-1. LED Patterns (continued).
LED State
• • • - (3 seconds)
• • • • (3 seconds)
• - - - (1/2 second)
- • - - (1/2 second)
- - • - (1/2 second)
- - - • (1/2 second)
Meaning
NVR check sum error: Ethernet address and other server
parameters are set to factory defaults. You will have to
restore the Ethernet address from the back label before
you can use the server. Contact Technical Support.
Power-up tests passed. NVR checksum good, ready to
boot the terminal server.
Indicates that the server has detected a factory default
Ethernet address (00-00-00-00-00-00), and is
investigating whether factory test hardware is present. It
will attempt normal boot procedures within 3 seconds.
APPENDIX C: Power-Up Tests
59