MINOURA DS-150F Instruction Manual

• Fits up to 5-inch width fat tire.
• Install the Tire Rack together with the Wheel Support of on the Step-Bar.
Be sure the Tire Rack is not fixed and freely movable even though the
Wheel Supports are fixed onto the Step-Bar.
• Adjust the Wheel Support frame span prior to installing the Tire Rack.
• The shorter Step-Bar found in the original DS-150 doesn't come with the
DS-150F. Only the longer one is in the kit.
Make sure the shorter
!
guide side is positioned
inward of DS-150F.
Schematics
Cap Bolt M6x10
※
Plate Nut
Step-Bar
※
Insert the Plate Nut into
the hole on the Wheel
Support first, then put
the Step-Bar through
and tighten the bolt
from outside to hold.
Tire Holder for Fat-Bike
Tire Holder (Red)
Wheel Support
M6 Spring Washer
M6 Flat Washer
DS-150F
Wheel Support
Tire Rack
Step-Bar
Adjust The Frame Span
Cap Bolt M6x12
Adjust the Wheel Support frame span to fit the actual tire
width.
Loosen the M6x12 Cap Bolts, and change both side
Wheel Support frame position as equally as possible while
maintaining the red Tire Holder horizontal.
After adjustment, tighten the cap bolts firmly.
instructions manual
(ver.1.1 2016/9)
DS-150F
Warranty Period : 1-year
For more information, visit:
http://www.minoura.jp/
english/support/cs/contact.html
<Overview>
Be sure the Tire Rack is
positioned out of the Wheel
Supports.
Span
Tire Holder (Red)