Belvedere 8600 Installation And Plumbing

Shampoo
Bowls
8600 BACKWASH SHAMPOO BOWL
WITH VACUUM BREAKER
AND MODEL 522 FIXTURE
INSTALLATION AND PLUMBING
NOTE: To familiarize yourself with the various
components, please read instructions through
before starting.
1. Attach the fixture to the bowl according to
the instructions packed with the fixture.
TO ATTACH HOSE RECEIVER TO
BOWL (STEPS 2 thru 6).
2. To make hose receiver installation easier,
complete these steps to cut screw threads
in the mounting holes:
S Take a mounting screw and drive it
2 or 3 turns into one hole.
DO NOT OVERTIGHTEN.
S Remove the screw.
S Repeat for all four (4) mounting holes.
If the bowl is not equipped with a vacuum breaker,
proceed to Step 4.
*NOTE: If you ordered a vacuum breaker,
your hose receiver will have two
holes for mounting the vacuum
breaker.
VACUUM BREAKER
MOUNTING HOLES
DRIVE
SCREW
IN 2 OR 3
TURNS
MOUNTING
SCREW
PAGE 1 of 4
8600 PIVOTING SHAMPOO BOWL
8600
3. Place the vacuum
breaker pipes
through the
Gaskets and the
holes in the
hose receiver as
shown.
Secure the vacuum
breaker to the hose
receiver with
two hex-nuts.
DO NOT
OVERTIGHTEN.
HOSE
RECEIVER
NOTE: Install the vacuum
breaker as shown.
If the vacuum breaker is
installed backwards,
it will interfere with the
Spray.
4. Place the gasket
over the flange
on the bottom
of the hose
receiver.
HOSE
RECEIVER
GASKET
One Belvedere Boulevard, Belvidere, Illinois 61008
Printed in U.S.A. 4001024 Rev. 09-07
VACUUM
BREAKER
GASKET
NUTS
VACUUM
BREAKER
Belvedere USA LLC