Page 1
Safety View Model SVM-M718-4DVR Safety View is a registered trademark Installation and Operating Manual Copyright 2019 safety View. No part of this manual may be reproduced, modi- fied or otherwise used without prior Please Read This Manual Before Installing and Operating...
Safety Instructions Notes Thank you for purchasing Safety View backup camera monitor DVR model SVM-M718-4DVR. Please read through this manual before installing and operating this equipment. CAUTIONS: Please read the operating manual carefully and keep the man- ual in the cab for future reference Please do not install this monitor where it can obstruct the op- erators' safe view.
Components Notes Before you begin to install your new Safety View backup camera system, please check that you have everything needed for the installation. What’s in the box 1. One 7” 4 ch color monitor with DVR and remote 2. One Steel U-Bracket or Ram mount 3.
Monitor installation Remote Control Functions Installation Step 1 Find a safe suitable location for mounting the DVR monitor. Make sure it does not interfere with the opera-tor’s view. Mark the three holes in the u bracket (1) where the monitor will be permanently fastened. Drill three pilot holes for the bracket.
Page 5
Operating Instructions Monitor installation Monitor Installation After installing the SD card, Turn the power on Step 3 Mount video camera as per manufactures instructions. Route camera cables through equipment/machine being careful not to come into contact with Under the DVR mode, press MODE to switch record/playback, press ...
Page 6
Monitor Installation Monitor Installation Front panel Controls Specifications: Memory interface-1 SD card slot, Right side Operating power supply-12vdc or 24vdc Current-7.5 watts Operating temperature-(0c to 60c) Storage temperature- (-10c to 70c) Mounting–Metal u-bracket Visor-Removable sunshade ...
Page 7
Monitor Installation Monitor Installation Specifications: Visor (removable) IR receiver LCD—7” 16:9 Digital TFT LCD Subtract -/Left Resolution—800 x RGB x 480 Menu Remote control—IR wireless remote Addition +/Right Menu Languages–English, French, Dutch, Power on/off, Menu page down ...
Page 8
Monitor Installation Monitor Installation Step 6 Connect the 4 pin female camera cable to 4 pin male camera input Wiring Connections on the wiring harness marked AV2. This is the rear camera connection. If you are connecting four cameras to this system, repeat steps 3 and 4. and connect the 4 pin.