Advertisement
VG-LB1300L LED Cyclorama Light User Manual
Insert the wire into the terminals and fasten the clamping device by a flat screw driver.
Push insert and chuck into housing (pay attention to the guiding keyway).
Fasten bushing.
The color-coding schemes and some possible pin identification schemes; if pins are not
clearly identified, or if you have any doubts about proper installation, consult a qualified
electrician.
R
P
O
D
ELAYING
OWER TO
THER
EVICES
The lightings can be linked in a chain by power cables which installed a blue and a light-gray
connectors on the two ends. The light-gray connector connects to the power out socket of
the first lighting, and the blue connector connects to the power in socket of the subsequent
lighting, and so on.
04
VG-LB1300L LED Cyclorama Light User Manual
The power cable must is a three-conductor 2.5mm
When the voltage is 110V, Do not connect more than 10 lightings in total to AC mains power
in one interconnected daisy chain.
When the voltage is 220V, Do not connect more than 20 lightings in total to AC mains power
in one interconnected daisy chain.
Wire color
Conductor
Brown
Live
Blue
Neutral
Yellow/green
ground
P
I
HYSICAL
NSTALLATION
This lighting can be placed on a horizontal surface such as a stage or clamped to a truss or
similar rigging structure in any orientation using a rigging clamp.
When suspending the fixture above ground level, verify that the structure can hold at least
10 times the weight of all installed devices.
Verify that all external covers and rigging hardware are securely fastened and use an
approved means of secondary attachment such as a safety cable.
Ⅴ CONTROL PANNEL
B
UTTON
2
cable.
Symbol
L
N
05
Advertisement
