Partner PAT-120 Quick Start Manual

PAT-120 Quick Start Guide
Federal Communications Commission (FCC) Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
( 1 ) This device may not cause harmful interference, and ( 2 ) this device must accept any interference received,
including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Non-modification Statement
Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the
'
user s authority to operate the equipment.
SAR notice
The highest SAR value for the device as reported to the FCC less than 1 . 6 W/kg (limit set by the FCC is 1 . 6 W/kg)
when placed next to the body. The FCC has granted an Equipment Authorization for this device with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines.
Taiwan NCC
一�設� 低功率電波輻射性電機管理辦法第 � 條
( 12 14 )
經型式認證合格之低功率射頻電機 ， 非經國家通訊傳播委員會
•
功率或變更原設計之特性及功能 。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信 ； 經發現有干擾現象時 ， 應立即停用 ， 並改善至無干擾時方得繼
•
續使用 。
前項合法通信 ， 指依電信法規定作業之無線電通信 。 低功率射頻電機須忍受合法通信或工業 、 科學及醫療用電波輻射性電機設
備之干擾 。
Battery Warning
Li-ion batteries can be dangerous. There is a danger of explosion if the battery is incorrectly replaced. Do not
expose to fire or water.
To reduce the risk of fire or burns, do not disassemble, crush, puncture, or short external contacts. Dispose of
used batteries according to state or local hazardous waste requirements.
Safety information
Before installing and using the machine, take note of the following precautions:
• Do not place the unit on an unstable surface, cart, or stand.
• Do not block the slots and opening on the unit, which are provided for ventilation.
• Only use the power source indicated on the marking label. If you are not sure, contact your dealer or the
Power Company.
• When replacing parts, ensure that your service technician uses parts specified by the manufacturer.
• Do not place anything on the power cord. Place the power cord where it will not be in the way of foot
traffic.
許可 ， 公司 、 商號或使用者均不得擅自變更頻率 、 加大
(NCC)

Identifying components

Vol- Vol+ Power*
Front Camera
"
10 . 1 Touch Panel
Docking
Printer Door
MSR (optional)
Release Button
Feed Button
IC Card Reader
(optional)
Rear Camera
DC-in Jack
Micro USB 3 . 0
Mini HDMI
Headphone +
Mic 3 . 5 mm
Printer Door
Fingerprint
(optional)
DC-in Jack
Cash Drawer LAN
Note
* Tablet can only be powered off when Docking Power Switch has been turned
off.
SIM Slot (optional)
Speakers
RFID (optional)
Power Switch*
USB
USB COM