Philips DVP3350V/05 Quick Start Manual page 2

1
Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only
1
after you have finished hooking up everything. Never make or change connections with equipment
connected to the power outlet.
2 Connect the EURO AV1 AUDIO/VIDEO on the rear panel of this DVD/VCR to the SCART input on
the TV using the SCART cable (not supplied).
3 Connect your existing RF cable from the Antenna TV signal directly to the AERIAL jack on the rear of
the DVD/VCR.
If you have a Cable Box (or Satellite Receiver), connect the OUT jack of the Cable Box/Satellite
Receiver to the AERIAL jack on the DVD/VCR using an RF coaxial cable (not supplied).
Connect the supplied black RF cable to the DVD/VCR's RF-OUT jack and to your TV's ANTENNA IN
4
jack. The TV's ANTENNA IN jack could be labelled 75-ohm,TV IN, or RF IN. Check your TV manual
for details.
Connect the power cords of the DVD/VCR,TV, and Cable Box (if applicable) to a power outlet.
5
Turn on the TV power. Set the TV to a video channel. (See the accompanying DVD/VCR owner's
6
manual for details.)
Press STANDBY-ON 1 on the DVD/VCR or its remote to turn on the DVD/VCR. The first time you
7
turn on the DVD/VCR, you should complete the VCR setup. See the other side of this Quick Start
Guide for details.
SCART IN
2
For additional connection diagrams, see the accompanying User Manual.
Connect
To connect to your television, follow the instructions below.
REAR OF TV (EXAMPLE ONLY)
SCART IN
ANTENNA IN
ANTENNA IN
RF Coaxial cable (Supplied)
4
Scart cable (Not supplied)
Antenna
Wall Jack
Cable TV
or
3
4
REAR OF DVD+VCR
5
2