Advertisement
Advertisement
Summary of Contents for TBI PRO Engineering ELECTRONIC ZapLikePRO 360
- Page 1 User Manual...
-
Page 2: Table Of Contents
TABLE OF CONTENTS 1. INTRODUCTION 2. ATTENTION 3. WHERE AND HOW TO USE 4. HOW TO CHANGE ATTRACTANT 5. BULB REPLACEMENT 6. TECHNICAL INFORMATION 7. TROUBLESHOOTING 8. CUSTOMER CARE SERVICE 1. INTRODUCTION Thanks for purchasing our product. Please check the condition of the device before use. -
Page 3: Attention
2. ATTENTION - Do not use in inflammable and/or explosive locales and alike. - Check the local voltage codes before installing. - Do not intend to touch internal high voltage grids because of electric shock danger. Never put metal objects inside the net during use. -
Page 4: How To Change Attractant
Suggested suspension height: keep the product hanged at a height of 1.2 m at a distance of 0.3 m from the wall. OUTDOOR: 1. Hang the insect killer at a height of 6 to 8 feet above the ground. 2. Place the unit 25 feet away from the area intended for human activity. - Page 5 Place the attractant at the spot marked in red on the picture below. Wash hands thoroughly after handling. After skin contact: Wash with plenty of soap and water. If skin irritation occurs: consult a doctor. After eye contact: Rinse thoroughly with water for several minutes.
-
Page 6: Bulb Replacement
5. BULB REPLACEMENT 1. Disconnect the unit from the electric source. 2. Open the lamp by twisting the bottom tray in accordance with the arrows on it. 3. Use a screwdriver to remove the screw that holds the plastic gate. 4. -
Page 7: Troubleshooting
7. TROUBLESHOOTING Caution: unplug unit before servicing Problem Possible Cause Correction 1. Check fuse or circuit breaker. Check extension cord. 1. There is no 2. Check all sockets for electricity. A. The light is off and proper fit and 2. The lamp is not there is no high voltage alignment. -
Page 8: Customer Care Service
8. CUSTOMER CARE SERVICE...